Separate names with a comma.
the gauge hovers around 3-4 volts, and the abs light stays on and the tach dies.
so the other day my volt gauge dropped and the abs light came on, I limped it home where it died as I pulled in the driveway, my first instinct is...
the on ramp was downhill, and I didnt do the gears, they were done before I bought the car, but my GPS says the speedo is correct.
And as for...
alright, so mods are in my signature, dyno numbers are 268/303, and I did the old on-ramp test and did 0-60 in about 4.9 and 0-90 in about 10.5,...
holding it down at NC State!
that sucks I just replaced the friggin thing in 2005, and i havent put 20k on the motor since then, why would it be messed up again?
YouTube - harmonic balancer
so looking at that, the angle might not be as good as i originally thought, but its kinda wobbly, can anyone tell...
^thats effing amazing looking
I have one too, no clip at the moment, but it sounds quite similar to Rio's clip. Thats with bassani X and flowmaster delta 40s
so off and on my stereo will have this odd problem where the right side speakers will just blare, but the left is barely audible. I have the...
heres the chart
heres a few ive snapped at random, no modeling or anything
just for comparison does anyone know what stock 94-95 cobras, 96-98 cobras, and mach 1's put down?
I probably dont need the 24#ers, but at the time I was doing my stuff I got them pretty cheap and didnt want to leave anything on the table, and I...
alright, so I got my car fixed and manual tune (a/f and timing)
these are my mods:
mac cold air
pro-m 75mm for 24's
bbk 70mm tb
ok, car is done, got the vaccum leaks fixed and they tweaked the a/f and timing. Ended up with 268rwhp/303rwtq. I was expecting about 265, so i...
DEFINITELY go with the RTV, I used the cork gaskets my first time around, when I started the motor for the first time I got oil pouring out of...
I dont recommend the MAC headers, there is no solid flange where they meet the block, and it has caused me many blown header gaskets and headaches...
alright, so im getting the exhaust leak fixed, and while they were there turns out my valve covers were leaking oil big time, and where my lower...
they are the ford racing ones, i think 8mm.