Separate names with a comma.
After watching your vid clip, I don't think you have the proper preload on your lifters.
Yes you will have some noise from the rockers but, Yours...
look for a break in the pink wire from the switch out to the coil.
Place a jumper wire to both ends of the pink wire and try starting it.
From your pic's posted, you have the wrong starter.
It is a short nosed automatic starter, it will never contact the flywheel correctly.
Your best bet is to take a impact socket and pound it on the lock lugs and remove them all and replace with a new set.
Removal of the pink wire is done in various ways.
Depends on what your up to doing.
The pink wire is hidden in the main harenss behind that inst...
Repo flip down covers are not vented and are for show only as stated on the box.
I drilled a 1/16 hole in the caps center for venting, and it...
2+2Gt ahs perfect placement for installing.
Its just my 2cts but I would install the steering system and braking system BEFORE installing...
Hard to tell form the pic, but it looks like it is not deep enough for tumbler.
Best to measure the replacement for depth.
If it is, then some...
Its an Omen to get you back into a regular size car and out of that 2 seated roller skate....:rlaugh:
Removing the col lock is the same as the 70.
Removal of the collar takes pulling the TS switch up and loosening the 2 lock down nuts and lift the...
Short answer... No. But I would try it anyways.
But you may have enough room to twist the condenser upward enough to slide out the cam
You answered your own question.
That low of a rear is why your dragging your mpg down with a 5 speed.
Swap in at least a 3.50 and drivabilty...
A 180* stat will run at approx 187* in its fully open position.
I run a 180 in my 351CJ and it stays right at 185 while running down the road....
The 351C has a removable brass plate with an approx 7/8 hole.
The 351M is cast into the block.
If the plate has been installed for some time...