Separate names with a comma.
Zip tie sounds good too
I was thinking about the super glue also
The clip that holds the wire coulpler to my injector broke, how should I fix it?
or will it be ok like it is?
thanks,, I straighten it , some what close, I was wondering if they will split after this?
try a diff distributer
turn the motor over a little while you push down on the dist
I have an 89 fox mustang, that Im puttting a motor back in.
I noticed that where the plastic fuel line is molded to the crome fuel rail, it got...
do you know why it fell out
was it the plug behind the distributer, that sets back
Has anyone ever seen the press fit oil gallerie plugs blow out?
Is their a bad reason to run a high volume oil pump on a street driven 5.0 with HCI and supercharger?
take the trani out with the bell housing still bolted to the trani , then you might have to drill the bolt out from inside the bell
What should I use for The cork end pices for the lower intake gasket
Last time I used the cork ends coated with silcone, and it leaked,, [after...
per Federal Mogul,-- 6 thousands per every inch of bore, so for a 5.0 24-26 thousands
What range of rod and main bearing clearance do I want, on a HCI 5.0 with 10psi of Vortech
stock short block
I dont want you to feel bad ,but, We drove my wifes 89gt aod mustang to the Woodward dream cruise.
The car has edl heads ,stock cam with 1.7,s...
I dont remember why, I did it maybe 7 years ago.
it was that pink [Stallion ? ] converter,
Do you think my car will be ok?
I have an 89 mustang HCI , 2800 [pci] converter [non lock up] AOD car with 410 gears.
No trani cooler, but I did...
yes,,, Vortech said my kit would give me 8psi, My car has power pipe and I have 10 psi,...