Separate names with a comma.
but it still works noisy I think.
or am I being paranoid:scratch:
The valve opens when tightening the bolt rocker because preload lifters was less than .020 "
Yesterday started the engine.
Is that better?:)
Tomorrow I will try to interchange pushrods.
I will inform you of the results.
the second cylinder is at TDC
I set good used rocker arms and pushrods. And now valve opens while tightening the rocker arm's bolt.
You're talking about this? http://www.latemodelrestoration.com/item/LRS-6086AK/1979-95-Mustang-Cylinder-Head-Smog-Plugs-for-50L-58L
Some people consider that the short belt increases the load on the alternator bearings.
I installed a short belt. Everything is OK.
Mustang in Russia, though a rare car, but not unique.
I live in Yekaterinburg (http://en.wikipedia.org/wiki/Yekaterinburg). Mustangs 1st, 2nd and...
Stang stands. For new parts from US is not enough money yet. Delivery about a month is a lot, so missed half a season this year.
Now I'm waiting...
Today I measured the clearance between the valve and rocker:
1 Ex 0,35 Int 0,25
2 Ex 0,15 Int 0,05
3 Ex 0,15 Int 0,40
4 Ex 0,05 Int 0,55...
I mixed up the pushrods, everything else is set in the same position.
Yes, I know it
I they were in the oil for about half of the day...
this is my first experience with the engine.
I did everything by this book
I will tell the story in brief: I bought the Stang a year ago, the engine was now in this condition.
Mileage was 160,000 km
Please do not be...
I plan to check and remove all the elements of the valvetrain. I will measure the length of the pushrods, check all clearances.
I'll start next...
I removed the intake manifold and all the lifters right side.
One of the hydraulic lifters easily compressed by fingers. I replaced it. But the...
it was shown after lifter replacement.
pushers were not established in the same position, may be the cause of knocking?