Separate names with a comma.
i guess it will remain a mystery...
can you provide the two dyno sheets for those runs?
was the total timing the same for both runs?
did you do multiple runs with each...
my first welder was a cheap 110V unit i had picked up from TP Tools. The rollers/bearings got really sloppy and the liner was shot. I couldn't...
i indicated exhaust length has the largest impact. not the only impact.
i installed a straight through Magnaflow on my truck. it had a bad drone...
Drone in my opinion is simply an acoustic oscillation that occurs at a frequency to where the exhaust pulse pressure wave travels down the pipe,...
adding timing will help increase vacuum.
it's probably the flap/valve inside the muffler that's rattling. i can't imagine a second h-pipe would help.
1. Do you have a 351w firing order?
2. Did you overtighten the rockers when adjusting causing the valves to be open?
i would be absolutely ****ed if i took 28 oz parts into a shop for a balance job and walked out with a 50 oz imbalance (or more weight in the...
sounds good. i would have thought that crank was 50 oz. hopefully that's not the balance you're going with though.
not sure what type of rebuild your doing, but you should double what they did the balance with. if you went in with a roller block and associated...
when do we get to see the answer to see who wins?
390hp/430tq @ crank
no pics? part numbers? system description?
hard to read the sheet, but at least you know it wasn't some internet rookie putting it together.
i would want to know more details on the parts. (also haven't seen people running a mahle rod before). also i would want to know what machine...
this is an example of a set of borlas.
are your fenders on?
i sprayed it all from the outside. try making some sort of structure (like flat blocks to help you reach if that's the issue.
i was able to spray the engine compartment in one shot as the car sits in the following picture. i am fortunate to be tall though at 6'2".