Separate names with a comma.
Guide rod bushing is why I was in there and led up to this!. I have seen the lmr video 10+times now.
This is the best I can get when rolling it up with door shut. With door open its "ok" and goes fully up.
Did not change or remove weatherstripping
Would a weak or dying window motor hurt in the adjustment?
I have an 89 convertible that I just can't not get the window to adjust not mater what I try. When I put the window up with the door closed there...
I have an 89 vert. I plan to replace window guide bushing due to wobble in the window.
Seen the lmr YouTube video looknow straight forward.
Here is a picture of the orientation of the door handle rod.
I have a continuing issue of breaking the inner door handle only on the passenger side. It almost seems to me that the rod from the handle to the...
No sir I had not. It was mentioned above to check grounds. I am hoping to make the tach a winter project.
Where would I find the ground wires for the tach? I had this problem pop up again. Tach sits at 4,500 all day but does go up with more RPM. The...
So these problems are unrelated but started at the same time? Assuming all grounds are good?
Mikestang 63 can you point me in the direction of where they are? Or are they behind the cluster?
Well after driving a few times the Tach issue appears to be random. One time it goes to 4,500 other times it works. Random on when...
any one have a picture of the tach from behind?
Well this just sounds like a pain! Haha thanks again guys.
May have to wait till winter.
When driving today look down and my tach is at 4 and a half but engine is at idle. Key on engine off goes to 4 again.
jrichker once again your the man!. Just tell me where to send a gift card
Please. Do I not need to mess with this if I do not have cats?
Can this code be caused by the new hpipe not having cats? Or is that system just not functioning properly?
In addition is it worth removing the...
jrichker - I already have a jack and 4 jackstands and I have done plenty of work using them! I just needed some clearifcation for torque process...
I have some drive up ramps like the oil change ones. But I can't crawl under it lowred and do not have access to a drive up ramp