Separate names with a comma.
What rims are those?
I made my own tool. But the process is the same. And it can be tedious at first. I would start by taking the first cut about 1/3 as deep as the...
Correct, Tach output needs to go an aftermarket Tach. Seems like I remember the msd box fires the positive side of the coil versus the negative...
I was just there last Thursday. Shop is definitely doing some work. Whole place was packed with cars.
Yeah, I really liked those machined Cobras. I've had them for about 8 or 9 years on that car. I just felt it was time for a little change. I was...
Changed the wheels to black 03 Cobras.
What parts did you use for the 5 lug swap? My 03 cobras look nothing like that on the front of my coupe.
xe258hr or xe266hr
Just about any cam worth anything will need better springs than those gt40's have on them.
Someone probably installed the shaft from the top. So when the distributor was removed, it came out of the pump and into the pan. The shaft is...
That sucks, its in the oil pan! And thats your oil pressure issue.
Key? You mean oil pump shaft?
Well that's not good. I assumed at first that the engine had already been ran. Does it have oil in it? Not trying to insult you, but **** happens...
Just make sure the connection is real tight where the sending wire connects to the sender. Do you have a volt meter?
Are you sure you getting a good connection on the sender? What was the part number of the sender? Is this for the 93 foxbody?
If the gauge worked, then you just need to replace the oil pressure sender that is screwed into the side of the oil pressure port extension.
It should work with the car off, but key in the run position.
Take the wire off the sender, and ground it. It should peg the gauge if the gauge and wiring are correct.
Yes, a mass air setup has no vacuum line going to the BP sensor.