Separate names with a comma.
Ok, been doing a TON of welding in the trunk, wheel wells, got both quarters tacked on,
rear end finally bolted in.. Pushed it out to clean the...
Ok.. remember the Blah?
New wheel house, lots of welding, wire brushing, grinding, some POR, and Tada!
Now it's on to the...
I received a few more parts this week.
Got some new tail lights (lenses, buckets, bezel, all the screws, etc) new fuel filler (with gasket and...
I got a little bit of garage time again today..
Got a quarter cut off, and the new one fit.
I need to order some outer wheelhouses, wire...
Ok, been traveling a lot for work, then got sick, but back at it..
Not much, but here's the updates from the last few weeks..
Made a cradle...
Some more rust removal..
already cut corners out of the strip that runs all the way across the rear to get better access for the frame rails. It...
Wheels Style: AMR
Finish: Matte Charcoal
Placement: Front or Rear
It is 1.5" x 3" tube with a 3/16" wall thickness.
If I was ordering new steel, I would not have gone this thick, but It's something...
Man.. A sane person would have scrapped this thing..
Tonight I started cutting out some rusty frame rails.
Last foot and a half or so were bad,...
I have not welded new perches on yet, but I did buy some from Summit.
Right now I have the springs on the stock perches, and the...
Only had 3 hours today to work on the car.
I was able to rip out the old 6cyl rear end, and wheel the new 8.8 under it.
Looks like I might...
Got some tires delivered and mounted
So today I narrowed my rack, mounted up the front tires, and pushed her out of the garage, and spun her...
I was finally able to finish the right side frame rail, and mount the suspension on that side, along with the rack and pinion..
Fenders are just...
For the kit, I got a speedway motors crossmember kit, I also got the rack and pinion, and springs from them. The tubular control...
If anyone is interested in something other than Mustangs, here is the truck that took priority over the Mustang.. and No, it's not getting...
This is what I found under the front fender..
little rough, but once I scraped away all the undercoating, it was actually not too...
A little back story.. (or you can skip ahead to the photos)
Back in June I went to look at a 57 Chevy. The car was not what it appeared to be in...
Lol, Thanks anyway
I need to get out more and play with it, and need a zoom lens for sure, but so far it is a big leap forward from what I had ;)
Finally got a DSLR camera!!
So this weekend I got up at the crack of dawn and went to take some photos.
Car is my 2013 Deep Impact Blue Mustang,...