Magnetic flat head plus a small amount gear grease. The grease puts some friction on the pieces and can old them together.
The internals are the same and the block itself will handle more power than you can afford :P.
If its a 4v block, you will need to drill a coolant...
May I ask what heads you are running? You put out similar numbers to my car but about 30 less torque.
Do you have an oil pressure gauge? Might have snap the teeth on the oil pump earlier that day.
How much ground clearance do you have with the downpipe underneath the K member?
Do no skimp on your rotating assembly, get forged internals. If you must skimp, stick with the gt crank. They can handle lots of power.
Ford did it already.
YouTube - Mustang v10 mule
400rwhp or 400 at the engine? 400 at the engine is perfectly durable without going to a carb setup.
a timing adjuster is only going to adjust your base timing, you will be on borrowed time without a full tune.
Yes you will have to retard the timing, you better get a tune as well.
Clean out your TPS, replace the fuel filter and check your plugs. It should pull till 6k.
It also matters on your mid pipe.
In a price comparison, the trickflow heads + cams will give you more power for cheaper. Porting the 4vs and upgrading the cams will run you a lot of...
Mark Luton works with MMR.
Modular Mustang Racing-Your One stop shop for all your Modular Needs