I have a 91 5.0L with 10:1 compression
BBK throttle body
I am trying to choose which injectors to use, I am...
Is it possible to get the measurements and angles for the bars from the firewalls to the frame rails?
Because I want to buy one and not get ripped off
How can I tell the difference between a stock oem and a repro aftermarket hood?
Thanks for your advice. I am just curious why is FRAM that bad? Are they made from baby cows or something?
I just got my motor back from shipping. Here's the damage done to the motor.
Now the question is, is the $3.49 oil filter the only...
I worked at a shop in the last two summers, we used varsol. It worked awesome!
I am installing a year one 6 gauge bezel in my 65 Mustang coupe, and I must say it is an intensive install. The fit is going to be...
I am trying to figure out what is the cylinder head volume on a 1989 5.0L HO motor? I tried searching couldn't find the answer.
Try the Powertrax no slip system by richmond gear. It behaves like a locker, however, on turns it allows the outer wheel to unlock and rotate...
I think by far, a 65 coupe, silver, with torq thrust II's is nothing short of sex on wheels. The 65 mustang also not as long as the 67's, which for...
I am in the lower mainland as well, where abouts did you pick that Aerostar driveshaft up? The Pick a part in Chilliwack has...
I knew about the three wire and two distinguising qualities however, would I have to look at my heater switch to find out if my setup is a two speed...
I am in the process of restoring my 65 coupe and I had a couple of questions. For my heater motor, how do I tell if I have a three speed...
Hmm... I am going to be using the Walbro unit as a stand alone unit. As for the Aeromotive, would it be a good combo with the walbro?
Thanks to people on this forums I have decided to run a Walbro Gsl392 fuel pump for my 65 EFI coupe, my question is what setup should I...
I was referring to the driveshaft clearing the sides
I had a question in regards to running a 58 Ford 9 inch rear end in a 65 mustang coupe with an Aerostar aluminum. Will the driveshaft...
Timing for sub frame install
Is it best to install the subframe connectors before the powertrain is installed or afterwards?