Did the trans slide right in or did you have to force it? I have seen a couple instances where the input shaft caught the pilot bearing.
Factory or 3pc smoked would look soooooooo much better
Injectors should be ok. I wouldn't worry about a rebuild.
I saw the title and assumed this would be a thread about viagra
I put a mod motor in a camaro once. It was ugly and slow.
The stock cam works well with gt40 parts. I've run it before in an explorer engine.
Only one way to find out
They were likely assuming all things being equal that the builder has covered all ptv issues including push rod length. The shims are merely there to...
With some fender rolling and massaging it will work. I run 315s and after a lot of measuring and working they finally fit.
its been covered before, not sure if I read it in here or over at corral, but the overall lift on the stock HO cam is more than the the springs are...
When I did my heads I got them milled and rebuilt for around 300 including New springs, retainers, and freeze plugs.
Tap the ccrm with a rubber mallet. Then try again. If your timing chain snapped you would hear it when you tried to crank the engine.
I would highly suggest taking the heads,off and getting them cleaned and to have the springs done. Tell them what cam you plan to run and they will...
New valve springs are a must. Even the stock HO cam has more lift than they're explorers springs can safely handle.
The ho cam runs well with the...
Pistons are the same hyper units found in 92-95 gt's. The explorer's cam is a truck grind meant to make tq below 2500 rpms. You can use it but you...
70mm on the tv. Ideally you want a an 80mm maf but I ran an sn95 maf on that intake with no issues.
Youre just angry they didn't make chili cheese Doritos
meh. I think they look best without front plates.
as long as you have your stops adjusted correctly I dont see how you could go wrong. I DD'd mine for a long time and no issues. best part was...