Forgot to post this
Has gone 12.0's a few times now and on track to run 11's NA
Yes, it's possible.
May as well add to this.
Umm gas pedal is on the floor from launch to finish.
5800rpm launch, 6400rpm shifts, 3650 trans
YouTube - In Car 1.avi‏
Just another day at the track :burnout:
I run the Pypes as I got them dirt cheap(I wonder why) only issue I had was tube was in the way of steering shaft. I tried contacting them but got...
What size throttle body is that? I assume 90mm as I didn't notice it mentioned.
Ground wire, look on the end if fuel rail where it bolts to intake. The plug should go on stud.
I run MHS stage 2 heads and Nick got me intake valves ASAP after I had screwed up(bad mental lapse on my part) my cam install tweaking all 8 intake...
No experience with Strange or the FRPP axles.
I use 31 spline Mosers with a Detroit TruTrac and they have held up great to 6200rpm+ launches for 3...
Looks good and I always liked those wheels.
Lived here in Pittsburgh my whole life. Have driven nothing but rear wheel drive cars and never had any issues in the winter. Comes down to knowing...
My winter vehicle. Picked it up at end of June. '04 Ram with 5.7 hemi, about 7-8" lift, 35's. Needs the gearing changed from 3.55's to 4.56 but has...
Stock long block, Hitech stg2 cams, stock valve springs rev'd to 6400, exhuast, suspension, 4.30 gears and 10" slicks best [email protected]
"When turning the motor over by hand, with the plugs out, it almost "binds" up for a second, and then goes away on every revolution i make...it just...
Find the tire mfg website and look up that tire. Most always list specs including revolutions per mile. A tire size not setup right with computer...
Mac mufflers are pretty much only one's I run. I don't recommend using an X-pipe with them as it gives them a nasty raspy sound.
Nice, keep working at it you'll knock more time off :nice:
Just get that 60' quicker.