alright im pulling it out this week and dropping it off to have a 2nd put on the other side
its got an off the shelf ross piston off the shelf eagle crank and a set of GRP billet rods lol
yup its an off the shelf 347 set up... kinda
nah i will try and get some this week. we are getting the new heads tonight so we will be busy getting the turbo car running... BTW it was a no go on...
yea i could... id prefer not to but if it comes to it i can
yea mac long tubes. the o2 is sitting right on the trans pan
Driver side header... does your o2 sensor hit your trans pan?
Plates... im a big fan of them!
yea are def asking a lot out of that motor...
347" also :)
honestly it wont make a huge difference i wouldnt think... the heads are the weak point so thats going pretty much limit the rest.
FWIW we have a...
only good thing from alabama is the football players lol
thats not to bad for being done here... these were something like 20 bucks a set
guy i work with found a guy in china who makes custom head gaskets. he used them to make a head gasket for an old john deere tractor
the nitrous car has the head has the reciever groove and the block has the o ring. we used a bit of RTV around the water ports and a half bottle of...
you mean like a 3D printed plastic intake? its been done lol
yup singles up front and single afcos out back...
as for selling them. they might end up on my car for a bit while i figure out what i want to do...
Haha I think they are all coming off this year for mensers