i am partial to green myself my 86 notch is dark highland green (wannabe bullit)
wow i charge 175.00 bucks to do swap I am gettn boned
I use mothers leather butter and follow up with armor all
the stealth or the air gap works great I have used them both with great results
Never underestimate stock heads just throw on a set of 1.7 roller rockers and a cobra intake you will be happy with the result.
I do not know what camshaft you are using, to get the full potential. I would throw on a set of Dart Pro 1 195's or the TFS street heats,...
You can buy the trick flow spring kit out of summit and be good to .540 lift.
Your best bet is to take them to a reputable machine shop and have them checked.
I'll sell ya a D16Y8 V-Tec motor for $275.00... hahaha
Na5.0HO What do you want for your S/D harness and computer?
3 80lb bags of sand and som 225/50 Glacier Grips and look out. Who needs a 4x4
they were ported all the intakes that are stock other than the truck were oval
I didn't no I had to walk you to the bathroom, some things require a little common sense too.
Hole in the trunk floor, that is what you use the screwdriver and hammer for. It's only a mustang get over it.
I have 3 complete stock intakes who wants em.
Remove your rocker arm on say the #1 cylinder. Take a sharpie permanent marker and color the valve tip. Replace your rocker arms and rotate engine...
Dudu spray the rubber boot the filler tube slides into with wd40 and the tank will wiggle away from it. Put all the bolts on the body back. The...
What do you want to check for pushrod length I assume?
Mine do too thats funny you say that. My throttle body goes suck,suck and my pullies go spin,spin. C'mon you knew that was coming. Haaaaaaa!
It is usually $10.00 a hole to bore a block. Have it bored .030 or whatever cleans it up. Check all the tolerances in the main caps, and flatness...