The other point that I was trying to make and left out was you need to look at the difference in csa because looking pipe diameter will not give you...
The pipe numbers are for the outside diameter, but since I do not know the wall thickness I will use 2.25" and 3"
► (2.25/2)^2*pi =...
HP is nice to talk about, but if you want to broke things :D talk about torque.
If you go to the Tremec web site you will see that they rate our 5...
For thoughs on the go. - I have tested these calculators on both an iPad and Android Phone.
I have some calculators on my Web Site that will do the Math for you.
Rear Gear Requirements
Calculate Speed (MPH - Km/H) given RPM, Rear Gear...
Hard from your description to tell. You might want to check your IAC.
Check the gasket where the filler neck goes into the tank.
Thanks, I will do that tomorrow. A few years ago when I was doing something I saw it and seem to remember a light silver colored quadrant.
I have a 2000 GT 5 speed. I am the 3rd owner and have had the car for almost 6 years. The clutch will not disengage so I started to check it out and...
In a fixed RPM test the flywheel and drive shaft should neither add nor remove any HP. In a acceleration test the lighter parts will take less energy...
Stock 245-45-17 tires (Diameter = 25.68) 3.73:1 rear 4th gear 1:1 2440 = 50 MPH
On my web site you will find these calculators
From an article by David Vizard, Mod Motor Moves in the September 2009 issue of Popular Hot Rodding.
I have a couple of calculators on my Web site that might help.
Calculate Speed (MPH - Km/H) given RPM, Rear Gear Ratio and Trans Gear Ratio...
The graph is small and hard to read. it looks like it says 53.7 F 30.05 in-hg humidity 22% SAE: 0.9x I can not read the last number. where was this...
You do understand what effect weather has on the HP output of an engine?
BP = 29.92 Temp = 47 Humidity = 5% DA = -775
BP = 29.42 Temp = 69...
You ran 13.69 with the 104.29 with 2.26 60'. Maybe where did .5 (1/2) second of et go might be a better question.
Is the transmission down shifting when you go to full throttle at 20 mph in second gear? :shrug: If not this is the problem.
Stock tires (245-45-17 - Diameter 25.68") 6000 RPM 3.37:1 first gear
Rear ----- MPH
3.27:1 - 41.61
3.73:1 - 36.48
4.10:1 - 33.19
4.30:1 - 31.65...
A stock motor with a 100 HP shot will produce torque of over 425 @ 4000 RPM. The lower the RPM you spray at the higher the max torque.
377 Nm = 278.06 lb.-ft @ 3516 RPM = 186.15 HP
366.6 Nm = 270.39 lb.-ft @ 3550 RPM = 182 .77
These HP number look like what is on the graph