Separate names with a comma.
sand off the rust and paint it. as for the engine supersixmotorsports.com and tmaturbo.com or procharger
If it was additives it would affect more than one cylinder.
A bad injector is a possibility.
Your right they put a divorced dual exhaust on it. I never liked it when people that ether. Its never easy to work on.
That looks like over heating and detonation. Is your car stock or boosted.
sounds like it chould be a vacuum leak. check all of your hoses. you can test by spraying brake clean around the intake and all of you vacuum lines....
I believe its just the button that should light up
Do you have the filler neck unbolted from the body of the car at the gas cap?
the neck is some times hard to pull out of the tank, also get a new...
Yes a gt cat back will fit if you have a H-pipe or X-pipe for a v6.
Theres nothing wrong with mac exhaust.
Thats a very good setup, make sure you get the stage 3 heads to. It really helps. As far as gas mileage I get 18mpg but I could get more from the...
You can make a lot more power than that. I have a 3.8 with a procharger D-1sc making 550hp.
You can make that easly with a twin setup with forged...
thank you thank you
I have a guy that will sell me his toploader that came out of a 66 I6 mustang will it bolt up to a 302? Is it the same trans as one that goes behind...
Spraying through the maf is the only way you can run a dry set up. It will not hurt the maf.
try another ground that one may not be a good source of ground.
It's an easy fix. I fixed mine in about an hour start to finish.
its hard to tell from a vid. but seeing as you over rev'ed it you could have bent a valve.
The part# is 8R3Z 13A656-AA and it sells for $91 at the ford dealer
same here I come around every 3 months or so to see whats going on.
Follow the instructions to a T and you should be ok. I'll help in any way I can.
On a nother note. I'll be installing a new hydraulic cylinder on the...