Separate names with a comma.
First has anyone used a foger with a typhoon? Are there reported probs. with puddling?
Im going to do a 100 shot and Im curious what the total...
At the bottom of step 2 It says....
"Pull the small wire off the starter solenoid so engine will not crank. Have an assistant try to crank the...
89 5.0 with MSD Dist. wondering if is possible ti check if the module is bad?
Going through the "crank but no start" check list.
Great info here.
6" up the wire harness or from computer in mounted position. Reason i ask Is because I pulled the computer and followed the harness 12-14 inches with...
I've seen the wire diagram but not sure where it's located.
red/green wire on the coil reads 0 volts.
Will a ECM from a 88 work for testing.
Is there any way to check the TFI module? I have a MSD Dist.
Also I check the fuel injectors and there reading 4.79volts.
I jumped the fuel...
Sounds like you need a 75 shot.
Theres no substitute for cubic inches.
02 Is the last year of the ls1 F-Body
I cant seem to find the testing port to jump th fuel pump But I've checked the power at the fuel relay and it's 12v.
Im confused about the pump...
Where the heck do you get a blower for $1500??
Why are 4.10's to much for heads and Cams? I heard there the first things to do to these Mustangs....
New in the 4.6 world. Helping a friend out on some research on performance mods for the Modular 2v W/PI heads.
So far he's done Mac cold air, C&L...
Just had the same type of prob. It was the U-joints.
Id replace both ends, drain your tranny then re-fil it. Mine were so bad It was vibrating...
Changed ignition switch, computer, checked fuel relay, Fues links have 12v before and after. reset enertia button. Stumped on this one. All out of...
Has anyone ever changed the ignition switch. Is it easy to replace? Can they short out?