Separate names with a comma.
Want to buy TKO bell housing... Found one disregard.
Please PM me if you have one to sell.
That's not bearing material.
I would at first think your pump is going, but you said the pressure is high, so that aint it.
How long ago (miles)...
My vote goes to fordstrokers and Jim.
Check your damper and pulleys.
Ya never know...
The bearing is more than likely a "babbit" bearing, consisting of a bronze/copper base laminated with tin and lead or lead alloy...
There will be tell-tale crap in your oil. I'd check that right away.
The pins should be in a bag.
A long one and a short one.
I wouldn't accept a rotating balance error of .5grams and higher.
Most average machine shops can get inside of .3 grams easily.
CHP is REALLY...
I now understand why you're proud of your ignorance, and heading toward stupid because you refuse to learn, even when faced with facts and proven...
Okay, here's what my dealer posted to me for you;
So, as you can see, it's opposite what I had thought.
The guy you talked to at DSS obviously has no clue.
He probably thinks an engine doesn't need air and fuel to make power either.
At say 6000rpm,...
Lemme ask my dealer if those pistons weigh the same.
I'm inclined to say "not" due to the fact the taller compression height piston has more piston...
Dealing with Coast High Performance is a GOOD THING!
I cannot believe they sent you that FUBAR setup without going through QA first.
The 347ci pistons with that stroke (3.4") require a CH of 1.090". That will be the difference in weight.
That should change your bobweight imbalance...
What rods did you get... I or H?
Lightweight/ultra-lightweight or standard?
You should ask the Dealer you bought them from the same question...
I suggest a standard Holley 750dp. Depends if you know how to tune.
I would not use anything smaller than a 650.
Again, the choke horn is up to...
Fittings from Aircraft Spruce
The diameter of the wheel is not "wheel base".
Wheel base is the distance between the front hub and the rear hub centers.
To answer your question...
130# springs ARE drag racing springs.
The OP has posted his installed equipment, which makes his front side about 80# lighter than stock....