Separate names with a comma.
Where did the car end up...still in Vegas?
Did this once. The pump made a hairline crack and would leak oil when hot. It took me a while to figure it out.
After trying to quickly and...
Sounds good man.:nice:
I dont mean to be THAT guy, but those welds looked really cold.
I really hope there was good weld pennetration.
Oh, and you can get a mig...
Where are you at?
If you are near CA, I will make you a smokin' deal on an entire carb setup.
Hard to believe the axle is bent and the housing is not.
If they end up totaling it out, liet me know. I am looking for a project.
Are they pedestal mount or stud mount rockers?
Do you have the correct length pushrods?
Do you have all the tools to do it?
I dont know many messicans that are named Dave...:shrug:
:scratch: Actually, I dont know any...
Did you get tubes for those things?
What pistons are they?
I am pretty sure they are either closed, or in the process of closing. They just had a few auctions and sold a whole lot of equipment, goods, etc....