Search results

  1. dustang50

    Forced Induction High No Levels At E-check

    I have an '02 GT with a KB blower, have had it set up this way for 5 years with no problems. In Ohio you must pass an emissions check every two years. This year I went & it didn't pass because of high NO. Everything I read on this says that it's possibly a temperature issue. I'm not sure if...
  2. dustang50

    2003 Cobra, 33k miles

    Full Bassani exhaust, small blower pulley, Predator tune, cold air, chrome rims. 474 rwhp Asking $22k, obo.
  3. dustang50

    2006 Harley Davidson Custom Sportster 883

    7300 miles (approx), Screaming Eagle intake. $5000 obo
  4. dustang50

    Supercharged 2002 GT

    Too many mods to list, but here's a summary: - Kenne Bell w/ intercooler & boost-a-pump - Eibach Pro suspension (1" lowered) - Full Bassani exhaust (mid length headers, mid pipe, cat-back) - Racing seats w/ 4-point harnesses - boost & A/F gauge pod - 4:10 gears - Custom-tuned at Hutter...
  5. dustang50

    Full Bassani Exhaust

    I had this one in the Cobra section, but got zero responses. Hoping it works better here... I've had a full Bassani exhaust on my '03 Cobra for a few months now & can't seem to get over the fact that it sounds like a coffee can full of BBs when I step on it. Anyone else have this setup? Does...
  6. dustang50

    2003 Cobra Bassani Exhaust

    I've had a full Bassani exhaust for a few months now & can't seem to get over the fact that it sounds like a coffee can full of bb's when I step on it. Anyone else have this setup? Does it sound like that for you, or is something rattling around on mine?
  7. dustang50

    Ohio - West Side of Cleveland Shops

    Anyone know of a good shop out near Avon? I had been taking my cars to Hutter Racing in Chardon, but that's a heck of a drive for me now!
  8. dustang50

    Shorties vs Long Tube Headers

    I know that long tubes generate more HP than shorties, but how much better are shorties than stock? How many horses can I expect from them?
  9. dustang50

    Pics from the Strip

    Here are some pictures from the first race day of the year...
  10. dustang50

    Pics from First Race

    Since I'm stupid & can't figure out how to paste the images directly into the page, here's a link to the pics at putfile.com...
  11. dustang50

    Day At The Track

    Had my first ever day at the drag strip today... The car was running well, but I couldn't get any traction AT ALL through 1st & 2nd gear. My best 60 ft time was 2.138. :notnice: Talking to some guys there, they said that it wasn't bad for street tires, though. Best time was a 14.194 @...
  12. dustang50

    Valve Spring Life

    How long do the stock valve springs last? I have 63k miles & am just beginning to race my car, although it still sees more street than strip. I'd like to follow Killgore's lead & do some preventative maintenance before I run into any problems. Is there anything else that I should be...
  13. dustang50

    Is a Custom Tune Required?

    Do I need to go to a dyno shop & have the 'stang custom-tuned after installing the items listed below? * Ported/polished plenum & TB * K&N FIPK * New Midpipe It's already been tuned by a Superchips handheld.
  14. dustang50

    Problems...

    After a winter of storage, I finally brought the car out today. This winter I made the following mods/service: * K&N FIPK * IAC Restrictor Plate * Ported/Polished Plenum/TB * Replaced PCV Valve * Replaced plugs I attempted to install a midpipe, but had problems with a bolt so I put it...
  15. dustang50

    PCV Valve Replace

    Any tips on getting the hard plastic boot off of the old PCV valve?
  16. dustang50

    Tune Up & Midpipe Install

    Just got done replacing the plugs. I had read that you had to shut the fuel off to the rails, run the engine until it stalled, unbolt the rails & pry them back, blah blah blah... None of that was necessary. In fact, it was as easy as changing them in my old 5.0. I guess I was intimidated by...
  17. dustang50

    Exhaust Install

    I have an old, rusty stock h-pipe that I'd like to take off & replace with a new, shiny Bassani x-pipe. I've never done anything with the exhaust before. A few questions... 1) Is this something that I could do myself w/o any special tools? 2) Would weld-in flows change the install?
  18. dustang50

    Gear Install Kits

    Are gear install kits a universal fit? For example, will a FRPP install kit work with Motive gears?
  19. dustang50

    Fuel Filter

    Disregard this thread...
  20. dustang50

    Fuel Filter

    Any recommendations on which brand to use, or are they all the same? I figure that OEM will do just fine with the stock fuel delivery system, but if there are alternatives I'm open to suggestions!
Top Bottom
Back
Forums
Menu