Search results

  1. AZNEAL311

    WOT questions

    When ever i go WOT my car falls on its face, doesnt matter what gear or rpm. If i want a decent launch i have to find a sweet spot in the throttle(a little more than 3/4). Anymore and she falls on her ass. Just replaced stock injectors with 24# with calibrated MAF, new holly 190lph fuel pump...
  2. AZNEAL311

    Help with Fuel Rail install

    I just bought a set or billet aluminum fuel rails. It is just the rails and regulator. I bought the Russel adapters for Ford EFI to AN. the pressure side is 8AN and the return is 6AN.Is that right? Do the stock rails disconnect lower near where it turns into rubber as well as up near the...
  3. AZNEAL311

    FlyWheel HELP

    I just bought a stage 3 clutch with aluminum flywheel. The Flywheel came with both 28 and 50 oz weights. I know a stock 88 5.0 is the 50oz but ive also read stuff like strokers,306s or any thing with custom internals could have been balanced for 28oz. The guy I bought the car from didnt build...
  4. AZNEAL311

    Flywheel weights??

    I recently bought an aluminum flywheel and it cam with 2 different weights. It does not say any thing about them so I have no idea which one to use. Anyone have any idea?
  5. AZNEAL311

    Gripforce F1 clutch

    Well I have my engine out to replace my oil pump. Since it is out I figure I should do a few things to save me some trouble later on. Replaced the rear main oil seal with a teflon seal. I also decided to get a new clutch. Im looking at one from Gripforce. A stage 3 F1 rated at 550HP and 487...
  6. AZNEAL311

    EFI Lift Plate

    Anyone in the Phoenix,AZ area know where to get a lift plate for EFI 5.0? Im finally going to have time to pull my motor this weekend and I am in need of a lift plate ASAP. Ive tried every where I can think of with no luck. I would normally just order one from Summit however I dont have time to...
  7. AZNEAL311

    Oil Pump Drive Shaft Pics

    Oil Pump Drive Shaft I lost oil pressure a while back and am just now getting around to fixing it. I am not to excited about pulling the motor just for a bad oil pump. Ive heard so many different reasons as to my I might have lost pressure, from bad pump, drive shaft slipped out, blown block...
  8. AZNEAL311

    No oil pressure

    I started the car and went to drive off and noticed a metallic grinding,rubbing noise. I checked my dash and saw no oil pressure so i shut it off. I popped the hood and noticed there was oil every where one the backside of the motor. Even on the hood,firewall,wires. It all seems to be coming...
  9. AZNEAL311

    Timing Question

    Any suggestions on what i should set my timming to? I have tried several differant settings and cant seem to get it right. Its at 18 right now. I heard the stock pointer isnt very accurate. At one point I had it all the was up to high 20s almost 30 and it seemed to run good but it just seemed to...
  10. AZNEAL311

    What do you think of this motor?

    I was just surfing ebay and came across this motor. Any ideas on how much power its capable of putting out? Think its worth the $$$? It looks good even tho its yellow...
  11. AZNEAL311

    CODE HELP

    Finally got my car to throw codes. Turns out it was the computer. Just bought a new one and I got these codes. 1. 22 which is MAP, I have MAF conversion so I disconected vac. line to it. So getting a code here is no problem... Right? 2. 81 3. 82 4. 95 Those are all KEKO. Please...
  12. AZNEAL311

    Computer Question

    Do I need a new computer if I get no reading from pins 46-40 & 46-60? And what are the signs of a bad computer? Right now my car starts and then dies a few seconds later.
  13. AZNEAL311

    Wont stay running.

    My car wont stay running for more than 20sec give or take. I just changed the head gaskets but I had the problem before I changed them. I also cant pull codes(whole other issue there). There is a red/light green or light blue wire I cant really tell, it is between the drivers side shock tower...
  14. AZNEAL311

    Wont stay running.

    My car wont stay running for more than 20sec give or take. I just changed the head gaskets but I had the problem before I changed them. I also cant pull codes(whole other issue there). There is a red/light green or light blue wire I cant really tell, it is between the drivers side shock tower...
  15. AZNEAL311

    Pacesetter

    I was looking to get a set of headers on a budget, it was BBK shorties or Pacesetters. Pacesetter is based out of my home town so I went with them. I got a set of equal length shorties. I was wondering if anyone else has used Pacesetter and if so what they thought of them.
  16. AZNEAL311

    Collars in coolant pass. between heads and block?

    I am replacing my head gaskets and on the drivers side there are a couple of collars that sit in the coolant passages but none on the passenger side. Could that be why i was leaking from the heads/block? My gaskets looked fine. Anyone know what they are or even what I am talking about lol. And...
  17. AZNEAL311

    Edelbrock Performer,RPM, @ RPM2 use same gasket?

    Title says it all, i am about to purchase some gaskets online and I want to make sure I get the right ones. They do not show a pic of the gaskets but say" TFS Upper Intake Gasket Kit for edelbrock intake/Trick Flow SBF EFI gasket. Performer/RPM. Pack of 4." That would be the gasket between the...
  18. AZNEAL311

    302 to 351 or not?

    A friend of mine owns a tow company and he is offering me a late 80s(88) I think Ford van w/ 351. He told me 120$ takes it. Van has around 100k miles with rebuilt AOD. Will my 302 Edelbrock Perfomer heads and RPM2 intake work on a 351 block? Im begining to think there is a lot more work involved...
  19. AZNEAL311

    Tips Wanted for Head Gaskets Replacement

    Im swapping out my head gaskets and Im having trouble getting it on the block with out damaging the gasket. I went to the 24hr Checker and asked for head/block alignment dowels and when they brought them up the were some kind of rubber seals. They didnt know what I was talking about. I thought...
  20. AZNEAL311

    Head Gaskets

    Ok so I go to start my car and it keeps dying right after it starts. I look under the hood and notice I am leaking fluid. It turns out to be coolant from a head gasket. She is smoking from the drivers side pipe(white). So my first Q, is would a blown head gasket cause the car to die right...
Top Bottom
Back
Forums
Menu