Search results

  1. N

    What's your impression?

    Any of you drive or have driven a fox with a full MM set up? F&R coil-overs, bilsteins (sport), TA&PHB? Just curious what your impressions are in all areas, handling, ride, body roll etc. Better or worse than, x, y, z.... Just looking for some feed back, looking at going this route...
  2. N

    2" silicon 90?

    Anyone know where I can get one today, anywhere from Vancouver to Eugene area is fine. I am working on my other car and the one I have is a little small (short) :( THANKS! :nice:
  3. N

    Turbo Q's / help / ideas?

    Ok so I have been thinking about selling my Cobra because I can't get it tagged in Cali where my work is moving me in the fall, but I got to thinking is there a foxbody turbo kit out there that is CARB approved? I hate to sell the car it makes me sick to think about it after all I have put into...
  4. N

    Moving to Camarillo have some Q's

    So I am moving to cali for work and I am wondering about keeping my foxbody there. Can any of you guys give me the low down on how hard it is going to be to get her legit in Ca? Maybe I should just keep the Oregon tags on it. Aside from that is there much of a mustang scene in the ventura /...
  5. N

    wilwood Brake line question

    Do you guys know if there is an adapter to go from the hard lines on the rear end of my 1993 cobra to -3an male. I have wilwood calipers and the brake lines in the kit are -3an female on both ends. I have a 90 degree adapter to go into the caliper but I need to adapt the hard lines on each...
  6. N

    Wheel Help

    I went 5 lug with the cobra r brembos and I need to start shopping for wheels, can you guys help me build a list of wheels that you know will clear the brembo calipers? The only ones I know for sure that will clear are the two wheels offered by maximum. thanks for the help....it's a black...
  7. N

    steeda 5 link 2 vs. Torque arm / panhard

    What is your take on wich set up would be better for a weekend racer that does see some street driving, the 5 link or a torque arm / panhard set up? Anyone have some feed back from using the steeda 5link 2.
  8. N

    5 lug swap question

    I have a set of 3.8 spindles off a 97 in the garage are these the same as the ones that came on the gt's and cobras? If so this will same me some cash on my 5 lug swap, I know they are 8mm wider then the 94-95 spindles but just not sure if the v6 and v8 spindles were the same in 97. Thanks!
  9. N

    Need help

    I need to upgrade the brakes on the cobra and go 5 lug, what should I go with? a) 96-> cobra f&r b) Cobra r front and reg. cobra rears c) Wilwood front(superlite 6) + ??? Rear (over kill?) d) ??? :shrug:
  10. N

    GT-40 head Q's

    What were the specs for the gt-40 springs that came stock on the 93 cobra gt-40 heads?
Top Bottom
Back
Forums
Menu