Search results

  1. T

    D&D Motorsports

    Does anyone have a new number for D&D I have tried the 661-260-2226 and it has been disconnected. Does anyone know if they went out of business?
  2. T

    Inner Shift Boot

    Is the inner shift boot for a t-56 and a t-5 the same? This is the metal one that screws to the floor board and has a rubber boot that keeps the road grime and noise out of the cabin. This is going on a 88 LX Hatch. I have the FMS 5.0 t-56 Thanks for the help. T3
  3. T

    Help Alt. Wiring issues

    I have looked in the sticky for the 3g wiring upgrade for my car, and I understand what needs to be done. however I have talked to another person who did not hook up any wires to his Powermaster 140a except the main 8ga line to the solenoid. He says this has worked for him for for a long time...
  4. T

    RAG JOINT

    I have what i belive to be a bad rag joint on my car. Can i replace the joint with a aftermarket disk or should I get a new lower shaft? It appears that one of the straps on the rag joint has broken b/c you can turn the shaft one way (about a 1/2 turn) and rack the other and then it will catch...
  5. T

    T-56

    Does anyone have any information on a t-56 to 5.0 mounting issues. My problem is I do not know which starter spacer plate I need to use. Will the stock t-5 work? Do I need to call Mcleod? The t-56 I have is from FRPP and is made for the 5.0 block. I just do not know which plate I need to use on...
  6. T

    ECU TUNNERS

    DOES ANYBODY HAVE ANY SUGGESTIONS FOR A GOOD EASY TO USE TUNNER FOR A N/A 5.0 MOTOR? THE CAR IS A 88 FOX HATCH, I HAVE A D&D MOTORSPORT 342 WITH AFR185 HEADS, SYSTEMAX INTAKE, DIGITAL 6 INGNITION, MSD DISTRIBUTOR, FACTORY FUEL LINES AND RAILS, WITH AN A9L FACTORY ECU. THE CAR IS A MASS AIR...
  7. T

    FMS VALVE COVERS

    I HAVE A SET OF VALVE COVERS PART NUMBER=M-6000-F302**. I AM USING THESE ON A 302 WITH 1.6 TRICKFLOW ROLLER ROCKERS. I HAD TO TAKE THE BAFFEL OFF THE OIL FILL PORT SO THAT MY ROCKER NUTS WOULD CLEAR THE COVER. WILL THIS BE A PROBLEM? HAS ANYONE EVER RUN IN TO THIS PROBLEM? WILL THIS CUASE A PCV...
  8. T

    ECU QUESTIONS

    Guys I am new to the Stangnet forums. I need help with a ecu problem. I have a 1988 mustang lx 4 cly. I am coverting it to a 5.0 fuel injected car. There are so many ecu systems out there, I do not know which one is going to give the bang for my bucks. I have looked at a fast system, pms system...
  9. T

    T-56 BELLHOUSING

    Guys I am trying to put a Ford t-56 transmisson on a f4te 351w which bellhousing do i need to use. The package is going in a 88 lx hatch car. will it even work? any tips i can get would be greatly appreciated. thanks
Top Bottom
Back
Forums
Menu