Search results

  1. B

    Are wheel spacers needed

    for 15 x 3.5 rims. I picked up some new welds and wasn't sure if I needed them or not. Thanks.
  2. B

    Oil pressure drops @ W.O.T

    And then goes back up at cruising speed,Is this anything to worry about? I was thinking sending unit.
  3. B

    track times after trick flow t/e kit

    It's an auto with 3000 stall,shift kit,410's, 19lb fuel injectors,70mm mass air,cai,65mm tb,timing set at 13,street radials and no tune: 60' 1.996 1/8 8.686 @80.32mph 1/4 13.53 @102.12 I think with a little more timing,drag radials,and around 20 degrees cooler I can get real close to...
  4. B

    car started running hot after......

    trick flow top end kit and now that it's 100 in MD it's starting to over heat.During trick flow install i had the water pump replaced and a 180 Mr Gasket thermostat installed.The top radiator hose gets hot but is very soft,the oil looks clean so i don't think it's a H/G.I thought I might have...
  5. B

    Adjustable fuel pressure regulator

    Is there any performance gains if your running stock injectors and pump? Or a waste of money.
  6. B

    Does the TV cable.....

    have any effect on the way your car idles? Also is there anyway to tell if its adjusted correctly? Also I forgot to fasten the tv cable to the bellhousing bolt when I did my torque converter install. The transmissinn seems fine but now the car will rev up to about 1500 rpm's and die.I wasn't...
  7. B

    What's wrong with my car ........

    other than the driver.My first trip to the track after installing trick flow top end kit,65 mm throttle body,headman headers,bbk cold air intake,70mm mass air and edge 3000 stall lock up converter.And I gain 4 tenths.I ran 15.1 all stock and this time i ran 14.7@98mph with 255 60 street tires.My...
  8. B

    Installing torque converter

    I'm planning on installing a torque converter this week. Anybody have any advice or even better , a list of steps to make this as easy as possible.Thanks.
  9. B

    Catted H-pipe vs no cats

    How much h.p do you lose running a Catted H-Pipe? Is it worth swapping out every 2 years?
  10. B

    Installing torque converter

    I'm picking up an Edge 3000 stall lock up converter this week.Anybody have any suggestions or best steps to take when I do the install.Thanks.
  11. B

    What stall converter....

    Should I get? The car has a trick flow top end kit, 410's and it does have a shift kit.I want it to be streetable.
  12. B

    Professional products throttle body

    Anybody using one and are they any good? I seen it on E-bay,Blue oval industries sells them.150 $ for a 70mm with spacer seems a little cheap.
  13. B

    What will I gain.....

    I ordered the trick flow top end kit for my notch.It ran 15.0's all stock except 410 gears,h-pipe,flowmasters and sub frame connectors.It is an auto with a shift kit.Will h/c/i get me in the 13's ?
Top Bottom
Back
Forums
Menu