Search results

  1. K

    93 blue gt in dawsonville ga

    $3000 firm, need it gone asap 1993 Ford Mustang 5.0 Custom blue paint 17" black cobra wheels 245's up front 275's out back New radiator New gold top battery New heater core New IAC New air filter Just replaced timing cover gasket Just replaced water pump gasket New rear main seal...
  2. K

    93 gt 5 spd in ga $5000

    1993 Ford Mustang 5.0 Custom blue paint 17" black cobra wheels 245's up front with good tread 275's out back with good tread New radiator New gold top battery New heater core New IAC New air filter Just replaced timing cover gasket Just replaced water pump gasket New rear main seal...
  3. K

    Anyone have an A3M schematic?

    My computer and some wires got wet due to rain water getting inside. I pulled the computer apart and found 2 capacitors bad. One of them pulled right off and I am not sure which way the new one goes on (i believe they are polarized). So.... does anyone have an internal schematic of the A3M...
  4. K

    Center Port open or closed on lower manifold to head gasket?

    What is this port used for? The gasket I bought came with the option to block this port off. do I block it off or not? I blew threw the upper manifold where this port leads and it just dead-ends somewhere in the upper manifold. gt-40 heads and cobra upper.
  5. K

    67 shelby gt500 ORIGINAL parts

    My boss has these in the garage and was wondering how much they were worth... ORIGINAL: front grill w/ foglights in center (very rare) front grill w/ foglights moved further outside front sway bar carburator 2 cams aftermarket: carburator he has...
  6. K

    twin turbo: What radiator hose to use?

    As you can see: the radiator hose is in the way, not too bad, but i would like to move it.... What hose should I use and where can I get it? It needs to 90 closer to the radiator...
  7. K

    I moved my alternator to driver side today...

    Used stock brackets (except for the belt tensioner)!!! Before:
  8. K

    belt tensioner pulley bolt????

    How do I loosen it??? I am starting to wonder if it is reverse threads?? It just won't come off....
  9. K

    Car died, need some help plz!!

    went out for a cruise today... All was well until about 30 mins in to it. In a parking lot (at idle) the car died. Started back up imediately. Went about 30 feet and at idle it died again. It started back up again imediately. drove to the gas station and got fuel. Left the gas station and...
  10. K

    Fuel pump 'whining'?

    My old walboro fuel pump was making a slight whining sound, and since I am putting twin turbos on next week, I upgraded to a 255lph walboro fuel pump. The whine went away for 3 days, and now it is back and louder than ever. Any ideas?
  11. K

    "Big Stuff 3"

    Have any of you guys used their system? I have no clue as to what it can actually do, how much does it cost, etc....
  12. K

    5.0 VS. 5.8 parts swap?

    I have a 302 Block and was wondering if my heads (gt-40), Lower Intake Manifold, Exhaust Headers, and Cam will fit in the 5.8??? Will any of them fit?
  13. K

    Flame Thower Exhaust

    These are my first two attempts without the propane, just extra fuel from the engine... I have a 20lb tank of propane that I want to shoot the system with if anyone can figure out how to wire three coil packs(see other thread)... Anyway I hope you enjoy and bigger flames are soon to come...
  14. K

    How do I wire three coil packs??

    How do I wire three coil packs for flaming exhaust?? I have the obvious one running the distributer and two more under the rear bumper to power two sparks plugs in my exhaust (the propane tank is in, and plumbed). I cannot figure out how to wire these into the car. I ran a hot wire from a...
  15. K

    powerdyne super charger KIT needed

    I bought a used powerdyne bd-11a and i need everything else to intall it and i cannot find it to save my life.... The SC doesnt even have a pulley on it, and i want the 9lb one... Clamps, hoses, FMU, and all the such are needed, does anyone know where I can get JUST the kit???? plus, do i...
  16. K

    Automatic Bleach Tire Squirter

    Just wondering if anyone has tried this... I had a brilliant idea! What I did was re-run my windshield washer lines to the rear of the car. Just un-plugged it from the firewall and ran a new line to the driverside wheel, where i T'd it and ran another line to the passenger wheel. I...
  17. K

    Exhaust is making weird noise and lost some engine power, plz help...

    1987 white mustang convertible 5.0 EFI. Cobra Upper and Lowers. Ported GT-40 Heads. Bassani headers and x-pipe. Not sure what cam is in the car but it is very aggressive (not stock). Cold Air intake. Mass Air. screaming demon ignition. 8mm plug wires. Not sure what size injectors but...
Top Bottom
Back
Forums
Menu