Search results

  1. 95Cbra5O

    Rear End Noise - Bad Carrier Bearings

    I have a 2014 GT with about 29,000 miles on it. I started getting a metal on metal noise from the rear end about 5,000 miles ago. So I took it to the dealership and they ended up replacing the carrier bearings. I picked it up and it seemed to be somewhat better. I thought all noise I was hearing...
  2. 95Cbra5O

    Cooling Fan Won't Come On

    The cooling fan won't come on at all. Not even with the a/c on. Checked all fuses. Replaced fan motor and relay module. Still no luck. Any help is appreciated!
  3. 95Cbra5O

    Cleaning Throttle Body

    I just pulled off the throttle body on my 95 and it has a lot of build up on it. Also the intake manifold has quite a bit of build up on the portion I can see with just the throttle body off. Is there anything I can do to clean the intake manifold without taking the whole thing off? Thanks...
  4. 95Cbra5O

    Air only comes out of defroster vents?

    No matter what setting it is on the air will only come out of the defroster vents. Does anyone know what the problem is? Thanks for any input.
  5. 95Cbra5O

    Car stalls when braking..

    Just got my car back from the shop. It had some transmission work, brakes, and a fuel filter done. They found that the speedometer gear was pretty torn up so they ordered a new one. It hasn't come in yet but I needed the car so they let me take it without the gear in it. The speedometer...
  6. 95Cbra5O

    Difference in 95 cobra transmission?

    Does anyone know if the t5 transmission that Ford put in the cobras is any differernt than the ones that they put in the other mustangs? Thanks for the help.
  7. 95Cbra5O

    Header install in progress...

    I have done the passenger side and am going to try and finish up the drivers side tomorrow. The problem I am worried about is the bolt closest to the front of the car, it is quite tricky to get to. Does anyone remember what they used to get to it when they did their header swap? Thanks
  8. 95Cbra5O

    Drama with the repair shop...

    About month ago I had a new clutch put in. They raved about Luk clutches so I decided to let them go with what they know. Then about a week after that I started getting a whining noise and as soon as I pushed on the clutch the noise stops. I take the car back and they tell me it is the throw...
  9. 95Cbra5O

    What length stage 8 bolts?

    I am about to order some stage 8 locking header bolts, what length should I get, 3/4" or 1"? I have percy's seal 4 good gaskets on there but the bolts keep backing out. If I reuse these gaskets should I pull them out and clean them off before I put these bolts on? Thanks for the help. Brandon
  10. 95Cbra5O

    What lenth of Stage 8 header bolts?

    I am about to order some stage 8 locking header bolts should I get the 3/4" or 1" length bolts? I have percy's seal 4 good gaskets on there but the bolts keep backing out. If I reuse these gaskets should I pull them out and clean them off before I put these bolts on? Thanks for the help...
  11. 95Cbra5O

    Driver seat went up but won't go down...

    I was elevating my driver's seat to clean underneath it and now it won't go back down. The motor runs but no movement. I looked for an obstruction but there is none. Is there anyway to get it down? Thanks for the help. Brandon
  12. 95Cbra5O

    Car is running like crap

    Basically what is happening is the car just bogs down when I punch it. At times I have even gotten some knocking. I had almost the same problem about 55K miles/6 yrs ago. At that time I had a tune up done on it. New plug wires, cap and rotor, plugs, and the injectors were cleaned. After...
  13. 95Cbra5O

    Torn rubber on emergency brake.....

    I'm sure this has happened to alot of people. What have you guys done to fix it because it looks like crap. Mine has town almost all of the way up and is barely hanging on. Thanks
  14. 95Cbra5O

    Need a nice car cover... Whats the best?

    I am having to park my car outside now :notnice:. I need a good car cover so it doesn't get beat up by mother nature Thanks
  15. 95Cbra5O

    Percy's Header Gaskets.... Any good???

    I was just curious if anyone has used these and what they think about them. Any input is appreciated. :flag:
  16. 95Cbra5O

    Headers keep leaking

    I put some headers on about 3 years ago and about a year ago they blew a header gasket. Than a few months after that it did it again and now for a third time it has happened again. It is always the back left gasket. Is there anything I can do to prevent this from happening again? Thanks for...
  17. 95Cbra5O

    Help me remove a trim piece w/o breaking it

    I want to remove the trim piece below the windshield. The one that has the wiper blades in it. Its faded and I want to repaint it. Anyone know exactly how to do this? Thanks for you help. Brandon
  18. 95Cbra5O

    Storing my car what do I need to do to my car?

    I am having to store my car for 2 months and I just need to know what I need to do to my car. Thanks for the help Brandon Hoffman
  19. 95Cbra5O

    1" wheel spacers enough?

    I want the wheels to come out closer to the fender, will a 1" spacer be enough? Thanks for you help Brandon
  20. 95Cbra5O

    Fake Snakes.....opinion???

    Personally I feel very fortunate to have a real Cobra, but does it bug any of you guys when people try to pass their mustangs off as cobras? A friend of mine has a 97 gt and over the summer he put on a rr hood, cobra front bumper and cobra rear bumper. He also put cobra badges on it...
Top Bottom
Back
Forums
Menu