Search results

  1. P

    Oil return for Procharger?

    I am building a Procharged 5.0 and i am trying to get some opinions on were to put the oil return instead of taping the oil pan. any suggestions
  2. P

    piston to valve clearance

    is it possible to run a 2.02 valve on a 20 degree angle around .515 lift on stock bottom end 5.0 out of a 91 fox?
  3. P

    World Man O War heads

    Can u use stock style intake on the 18 degree world man o war heads?...i didint know if they had the same angle on the intake as stock or if i would need another intake. i am gonna run a super victor efi intake?.
  4. P

    biggest Hyd. roller cam in 5.0

    I have almost everything together for my 5.0 motor. its a 91 H.O hydraulic roller motor with ported windsor sr heads. my buddy has a crane grind number 2030 216/220 .533 .544 does this cam have to much lift for stock pistons on stock stroke?. its gonna be a blower motor on 10 pounds of boost.
  5. P

    What kind of drive shaft? C4 in Fox Body

    I am putting a C4 in my 91 lx foxbody, what kind of drive shaft do i need?..will an AOD driveshaft work?
  6. P

    WHERE TO FIND A C4

    Hey gues i am building a Prochagred 5.0 to go in my 91 LX with Strange 31 spline rearend, 5 lug conversion. I wanna go with an automatic so i am looking for a C4 with manual Valve body and i havent decided on transbrake, but were can i find one thats a direct bolt in for a 91 lx 5.0?
  7. P

    car wont run

    My buddy and I just done a engine swap in his 93 LX and it wont run. It will crank and start up just fine, but when you let the key switch go back to the run position it dies. We replaced and Key cylinder and the ignition switch everything on the steering colum is new. any ideas? The car used to...
  8. P

    5.0 Main Bearing Problems

    I am basically overhauling a stock 5.0 shortblock right now. I took the block to the block to a local machine shop and they cleaned the block honed it and installed new cam bearings. now the problem. I bought a new set of Clevite 77 STD. size main bearings. I used Plasti-gauge and with a the...
Top Bottom
Back
Forums
Menu