Search results

  1. 9

    Water pump needs replacement

    So, the other day my water pump went. No big deal. Is it worth the extra money to get the edelbrock victor series high volume water pump? Or is the FRPP stock volume ample enough. I have had cooling issues in the past and i know the stock cooling system is barely adequate so i think this would...
  2. 9

    Autopartswarehouse.com

    anybody ever ordered anything off this site before? Heard anything Good/bad? Auto Parts Warehouse | Car Parts, Truck Parts & Auto Body Parts Online - Free Shipping on most Auto Accessories & Performance Parts – AutoPartsWarehouse Thanks!
  3. 9

    ssbc rear brake conversion

    Has anybody use the SSBC rear brake conversion kit? If so, are you happy with it? Here is the link 1993 Mustang 4-Lug Rear Disk Brake Conversion Kit by SSBC at LRS - Same Day Shipping! Can anybody attest to the build quality?
  4. 9

    Overheating issue. Pump maybe?

    I searched the forums for an answer and I couldnt find this problem so here it goes: How can you tell if a water pump is bad? I've replaced every hose, added a fluidyne radiator, new 195 deg. thermostat/gasket, and replaced the worn out crank fan with a new crank fan and sometimes (not...
  5. 9

    idle issue

    Today, I replaced my O2 sensors and swaped my MC platinum plugs for MC copper. Before this, my engine, when cold after ignition, would start and revv at approximtly 1800 for about 15-20 seconds and then rev down to 850-900rpms. Now after replacing those items, after a cold ignition it revvs to...
  6. 9

    stock spark plug gap

    whats the factory recommendations for the spark plug gap?
  7. 9

    Mass air/TB

    next two mods are a a new TB and mass air meter. what do you recommend? Im thinking a Pro-m 75 mm mass air and an accufab 70mm TB. Thoughts?
  8. 9

    rear end gearing

    How can I tell which gearing my 93 AOD 5.0 has in it?
  9. 9

    oil pressure

    This sounds like a newcock question but I'll ask it anyway. How do I check the oil pressure of my engine? Also how do I replace the oil pressure sending unit? Basically, while driving to clearwater beach today, stocker gauge dropped to below red at any RPM range. I don't know how long it was...
  10. 9

    Edelbrock RPM II Intake

    The next mod I'm planning for is an Edelbrock Performer RPM II intake with a BBK 70mm TB and an EGR plate. My motor will have stock heads and a stock bottom end at the time of the install. Am I going to run into fuel delivery issues with the 19# injectors? Eventually i'll upgrade the...
  11. 9

    Radio cuts in/out

    Im not to fantastic with electrical, so please bear with me. I've had this problem since I bought the car, but since its been basically parked I havent really had to deal with it to much. However since im about to fix the radiator and steering, I need to get this fixed since ill actually be able...
  12. 9

    thermostat

    My mustang needs a new readiator. I plan on getting a fluidyne. At the same time I plan on replacing the thermostat. Should I go with the 180 or the 195? I dont have any cooling issues except for the bad radiator. Which do you guys think will work best?
  13. 9

    Steering rack with or without offset bushings....

    so its time to replace my powersteering rack. A few questions: 1. 20:1 ratio or 15:1 ratio, what the difference? 2. reguar bushings or off set rack bushing? (Which do I need?) 3. Can anybody attest to the quality of these 50resto parts? This is what im considering: 85-93 Mustang Power...
  14. 9

    a/c problem

    I can not switch between max a/c, norm a/c, vent, floor, mix and defrost. Regardless of which selection i put it on, it goes to floor selection. It seems to be frozen there. the A/C works when its turned to cool, the heat works when it put to heat. any ideas?
  15. 9

    MAC off road h pipe question

    Tomorrow ill be finishing the install on my shorty headers and I will be installing my MAC off road h pipe. My question seems simple but im unsure of it. After all is said and done, will i get a CEL b/c of the cat delete? If so, how do I prevent this from happening? Thanks guys. JC
  16. 9

    fuel system

    Im going to replace my fuel tank. I want to know what parts I need to do the job right. Heres the list Ive come up with so far. Mind you, I don't want to replace any of the underhood items yet. Gas Tank Fuel Filler grommet Fuel Sending Unit Lock Ring For fuel pump/sending unit Fuel Tank...
  17. 9

    Codes

    okay, so i replaced the fuel filter today and what do you know, the car runs better. This fuel filter had about 1000 miles on it and it was horribly clogged. So now she runs better but its throwing some codes, KOEO memory code 95 and KOER code 12. The code 12 is for Idle Speed Control motor or...
  18. 9

    WOT bogs down, running very rich... any help?

    Okay, so my 5.0 has been running very very well since I got it running again. Just some background: All she really needed was a very good tune up (cap, wires, plugs, rotor, cleaned throttle body, new IACV, new TPS, oil/fuel filter, oil change, radiator flush, new pcv valve and screen, checked...
  19. 9

    AOD Filter change

    hey guys, sorry to be a bother with what seems like such a simple question but here it goes: From what I've read and seen, if your AOD has burnt/brown ATF fluid, it should be changed, but not flushed b/c the complete flush can ruin the tranny for whatever reason. I'm pretty sure that this (a...
  20. 9

    Another Mustang Idle problem

    I am new to the forum, but not new to Mustang motoring. This one has me stumped. Heres the situation: I just found this cherry 1993 Mustang GT so I decided to buy it. When I bought it, it would run strong during acceleration and cruising, but at idle it would die. First, I sanded down the burs...
Top Bottom
Back
Forums
Menu