Search results

  1. B

    C&L MAF cause both banks to go lean??

    Im getting a 181, and 189 error code. It says both banks still lean under part throttle. When the cars not warm it will crackle out of the exhaust when i shift. Sounds kinda cool but anyway.... It started happening after I put the new MAF in. Could that be the culprit, or does it mean something...
  2. B

    Cranks slow sometimes. Wont start others WTF!

    So my car is cranking really slow sometimes, and sometimes so slow it won't even turn over. Then other times it will start right up pretty much. I don't think its the battery, cause why would it be fine sometimes. They lights don't dim much when I try and start it. I thought the ground wire was...
  3. B

    Wont start, clutch safety switch??

    So its raining here. I go to start my car and i push the clutch in and my foot slips off and the clutch comes back up really hard and fast. So i push it back down and turn the key. It acts like it does when you try to start it when the clutch isnt in. I tried it both ways. Clutch in and not it...
  4. B

    volts up and down. bad ground??

    So when im driving and I hit a bump sometime the volts will drop wayyy down and the engine will even cut out briefly. Then if I hit a few more bumps it will jump back up to almost normal levels and run fine. Now if i shut it off when then volts are down it will crank really slow and not start...
  5. B

    Volts jump up and down. Bad ground?

    So when im driving and I hit a bump sometime the volts will drop wayyy down and the engine will even cut out briefly. Then if I hit a few more bumps it will jump back up to almost normal levels and run fine. Now if i shut it off when then volts are down it will crank really slow and not start...
  6. B

    volts down. Temp, oil guage pegged

    Like in the subject. The volts are way down on the guage and the temp and oil pressure guage go really high. So im assuming there is an eletrical problem. Sometimes the motor will even cut out, like theres no spark. When i go over bumps sometimes the volts will go back to normal for a second...
  7. B

    How do i change distributors..help!

    So i have narrowed an ignition problem to the pickup in the distributor most likely. So im thinking i might as well get a new distributor. How do i change them out. I know you mark the old one so you know where you took it out from. But how do you know where to but the new one back in?? I dont...
  8. B

    New MAF, Ignition mod, cap, rotor, still crap!

    So I replaced all that stuff cause i was getting a 212 ignition module circuit failure/spout connector grounded. Still runs like crap. Just the same as it did before....It bucks and misses at all rpms and all temps. the idle is really ruff as well. help!! Im starting to think it will never be...
  9. B

    Where to buy ProM 77mm MAF??

    The repair place says i need a new MAF. The ordered a stock ford one. So told them to forget it and give me the car back. Ill order a proM 77mm. So where is the cheapest place to buy one?
  10. B

    Venting!!!!!

    After taking my missing and running like junk to a ford dealership and them telling me to take it to a hi perf. shop(BS), i decided to take it to this local reputable place. I drop the car off monday. They call and tell me they think its running bad cause the smog pump isnt routed in the...
  11. B

    Freaking ford dealership!!! Help!!

    So I take my car to them to have them try and figure out what this code 212 is doing to my car. I just didnt want to start replacing stuff without knowing exactly what was wrong with it. So i drop it off, hey call me like two hours later and say they cant figure out whats wrong with it. They...
  12. B

    FORD dealership is so stupid!!

    So I take my car to them to have them try and figure out what this code 212 is doing to my car. I just didnt want to start replacing stuff without knowing exactly what was wrong with it. So i drop it off, hey call me like two hours later and say they cant figure out whats wrong with it. They...
  13. B

    Should i take my car to the dealership

    I can not find he problem to my code 212. I dont want to just start replacing random ignition stuff in hopes that it will fix it. How much do you think they will charge. Also, will they say anything about my o/r h-pipe?
  14. B

    code 212,311,314

    212 ignition module circuit failure/spout circuit grounded 311 AIR system inoperative during KOER (Bank number 1 with dual heated oxygen sensors 314 AIR system inoperative during KOER (Bank number 2 with dual heated oxygen sensors What do these mean???? My car is running like junk...
  15. B

    help reading codes!!

    I tested the codes and it blinks 111 111 1 212 212 what is that one in the middel between codes?? its throwing me off? Does it repeat the codes twice???? With Key on engine running im getting 311,,314 Which is 311 AIR system inoperative during KOER (Bank number 1 with...
  16. B

    Where is the test/diagnostic port for code reading??

    Shouldnt think be on the passenger side near the firewall??? I dont see anything on both sides of the car. Ive looked everywhere. Where is it?? Also, does Schucks do free code testing
  17. B

    Help!! still running like dirt.

    Ok, so i had a pretty bad exhaust leak. My car was running like shat. So i fixed that, cleaned my MAF. Reset the ECU(removed - battery terminal) And its still running like junk. It idles really rough when the engines cold and warmed up. It stays at about the same RPM 600-700 but shakes the...
  18. B

    Whats this bucking/missing

    My car in the last few days has been bucking at running like crap at rpms below 2500 ro so. Now i do have a pretty bad exhaust leak that i plan to fix tomorrow right at were the header meets the h-pipe. I plan to fix that tomorrow. It feels like its almost running out of gas, and turning off and...
  19. B

    Do you have to use the Idler pulley?

    I had underdrive pulleys on my car minus the alt. I used a 88.5 inch belt(smog bypass) My car was running a little hot at the lapping days with the bigger water pump pulley. So I put on the stock pulleys. The 88.5inch belt is to tight for it now. But, it fits perfect if i just route if over the...
  20. B

    Convince me not to buy a HONDA!!

    Ok so there is this guy at work that i am pretty good friends with. He will sell me his 95 integra with a good suspension on it, the b18c5 motor(type R), that has cams and a few other bolt ons. It also has the japanese front end. I drove the car. Its just as fast as my car, if not faster...
Top Bottom
Back
Forums
Menu