Search results

  1. NoSLowFiveO

    Balance ET streets?

    Got a new set of ET streets 26x10.5 going on 15x8 draglites. Im wondering if I should have them balanced or not. car is about 80% track. thanks
  2. NoSLowFiveO

    60ft times on radials

    anyone wanta make me feel better? I ran my car on a set of balding 24" dunlop radials and managed a best 60' of 2.16 It got me curious as to what times are good/bad when useing a street tire. so whats your best 60 on radials?
  3. NoSLowFiveO

    Ive got fuel delivery issues... looking for ideas

    havnt had alot of time to tune my car since getting it back together in July. I have found that I Dont have any fuel being delivered to the #1 cyl. The car has a new/rebuilt 306 bottom end, Edelbrock 6025 heads, AFM N-61 cam, and Edelbrock RPM upper and lower intake. 75mm mass air and 24#...
  4. NoSLowFiveO

    BBK long tubes and C4... will it work?

    I know the MAC LT's will slide around a C4 but will the BBKs? Ive already got a BBK short H-pipe and have heard that mixing the two brands causes problems. So... is anyone running a large or small bell C4 and BBK long tubes on a baby w motor?
  5. NoSLowFiveO

    What Plugs with Edelbrock heads?

    Got a new set of 6025. Need a recomended N/A plug and a N2O plug.
  6. NoSLowFiveO

    Will 1 3/4" BBK LTs fit with Large bell C4?

    Im pretty sure that the BBK's are only for 5 spd cars, just wondering if anyones got them to work with this setup? thanks.
  7. NoSLowFiveO

    C4 bell housing problems... need help

    Since Im C4 stupid, Ive been frustrated and pissed off looking at my setup for the past hour. I just bought a PA C4 with both a small and a large bell. My car is an ex-AOD car so Ive kept my 164 tooth flex plate and I purchased a precision industries stall converter with a 11 7/16 bolt pattern...
  8. NoSLowFiveO

    Pilot bearing removal

    So I made the mistake of leaving the pilot bearing in the crank on my 306. No that I have a C4 Ill need that out. So my question is, how do I get the bearing out when the motor is already in the car? thanks guys
Top Bottom
Back
Forums
Menu