Search results

  1. Blk91stang

    Checking Power to Oxygen Sensors?? How??

    I'm trying to wire up a Innovate LC-1 Wideband Oxygen Sensor and from what I gather I can wire it directly into the existing oxygen sensor harness that plugs into the factory narrowband oxygen sensors. It's for my Megasquirt setup. How can I test the factory oxygen senser harness to decipher...
  2. Blk91stang

    *Vids* In-Car 331 Supercharged

    Here's about the best I can get with my current tune. Tried all I can with the FMU setup with not too much luck besides keeping it safe (A/F drops to 10.2 on the top end). Will eventually go with a PMS but just wanted to have some fun with it before the seasons over. Should pick up another...
  3. Blk91stang

    No oiling from rocker on my 331 *VID*

    So for a while I've been having this "clattering" coming from what first thought was an exhaust leak and wasn't. Than I checked the rockers and this is what I found. It seems that #5 cylinder, intake side I believe is not getting any oil coming up the pushrod and on top of the rocker. All of...
  4. Blk91stang

    Take off supercharger belt for the winter???

    I know Vortech recommends not using the supercharger in the cold because of the tight tolerances which are used in the head unit, so I thought about taking off the belt this winter if I ever have to move the stang around for some reason. I figured this would be fine since I'm 90% sure the...
  5. Blk91stang

    G-Force T-5 Tranny Problem.... Tranny people I need advice!!

    Well I've had the tranny for about a year and a half now and had the driveshaft out about 5 times since than. Since the tranny was new, I had a problem installing the yoke of the driveshaft into the back of the tranny. Took a couple times to get it to slide all the way on and had bad vibrations...
  6. Blk91stang

    **PICS/VIDS** of new RNH 331 setup COMPLETE!!!

    So over the summer I decided to get a 331 built by RICK 91GT and slowly but surely got it all together before I went back to school. Here is a quick rundown of the setup. 1991 Mustang GT 331 Stroker using Stock Block 0 balanced 4340 Forged Eagle Crank 4340 H-Beam Eagle Rods Probe SRS...
  7. Blk91stang

    Stainless Works Chambered Mufflers Installed!!!

  8. Blk91stang

    Where does everyone mount their Line Lock On/Off Switch???

    Have Hurst Roll Control and need opinions on where to mount the on/off switch. Seems like no room on the shifter since the leather boot is in the way. Thanks
  9. Blk91stang

    Purpose of H or X crossover pipe in exhaust. Problem if I run straight duals???

    I want to run a "different" muffler setup and plan on splicing it into my H-pipe which means getting rid of the "H" junction in my Offroad H Pipe. I know on 4 of my father's corvettes, his sidepipes are not connected in any way and they run like raped apes (Despite everyone saying how much not...
  10. Blk91stang

    Why is this Steering Wheel different than all others I see???

    I just won this auction for a steering wheel which appears to be very clean. Now I wonder why there is no leather stitching around the wheel like my current one and every other mustang that I see??? Why does this one look like it's plastic or something? :shrug...
  11. Blk91stang

    Those with Flowmaster Catbacks on their 5.0's!!!!

    I need to know how the "Flow Tube-to-Muffler" joint is setup. Does your Flow Tube fit OVER the Inlet of the Muffler or does it slip INTO the Inlet of the Muffler? I'm trying to determine if my Flowmasters are 2-1/2" or 2-1/4". I currently have 2-1/4" stock flow tubes that fit INTO the...
  12. Blk91stang

    Went to the track, Is it time for a new motor??? Need Your Help!!!

    A little backround on my Combo. 130k mile untouched shortblock, cometic headgaskets, ported stock heads with the recommended RA finish for the headgaskets to seal. Went to the track tonight hoping my new Pro-Motion clutch was going to hold up (Worked Great!). Anyways after my 2nd run, I...
  13. Blk91stang

    Problem with my new Pro-Motion clutch setup *pic*

    So I got a new clutch setup from promotionpowertrain.com and put it in with no problems. Everytime I start the car the clutch feels smooth and fine, until about 20 min later it begins to chatter quite a bit from take off. With 120 miles on it already it doesn't seem to be getting any better...
  14. Blk91stang

    All single hook clutch quadrants the same? HELP!

    I currently have a Pro-motion FWA, BBK adjustable cable, and BBK quadrant. My question is do all single hook quadrants locate the cable at the same spot? My current setup with the BBK quadrant leaves me no more room for adjustment on my adjustable cable, let alone install a factory cable...
  15. Blk91stang

    Finally pulled out my Centerforce Dual Friction..... need advice

    ....and the disk is right at the minimal wear limit. 4 launches on slicks is all it took to completely take out the clutch ( 1 day at the track ). I really have no clue how it did this as my previous King Cobra never skipped a beat. I think i'm going to go with another King Cobra but 26-spline...
  16. Blk91stang

    People with stock clutch cables and Firewall Adjusters.. Need Help!!

    I bought this package http://www.buyfordracing.com/shop/product_info.php?products_id=374 and along with a UPR Firewall Adjuster (sets the cable housing 1/2" further away from the firewall than stock), the cable seems really short. From the looks it only sticks past the opening of the...
  17. Blk91stang

    Clutch Problems with new Centerforce Dual Friction and new G-Force T-5

    My Setup- - G-Force T-5 with upgraded everything and Pro 5.0 shifter. - Centerforce Dual Friction setup and Billet Flywheel. - BBK adj. cable and quadrant w/ UPR firewall adjuster (Clutch cable is setup as to have about 1 " of freeplay before beginning to disengage as to make sure...
  18. Blk91stang

    As Centerforce Clutch wears, taking up my pedal freeplay?? HELP!

    I installed a Centerforce Dual Friction Clutch about 1,000 miles ago with no problems (easy street driving). Finally got it to the track 2 days ago and after each pass, I would lose A LOT of freeplay in my pedal. I kept giving it more freeplay with my firewall adjuster. After 4 runs and maxxed...
  19. Blk91stang

    Trblshting Code 15- ECA... HELP!

    BORING TOPIC, I KNOW!! I just need a little help figuring this problem out once and for all! :shrug: Ever since I put my new combo together and got a custom chip burned for it, I can't let my car decelerate normally just by taking my foot off the gas and letting it slow down. When I do...
  20. Blk91stang

    What is the wire on top of my tranny?? HELP please!!

    I pulled out my old tranny to install the G-Force. On the top cover, the old one has a connector coming out of it and plugs into my factory harness. The G-Force doesn't even have a hole for the connector let alone a connector coming out of it. The only connections my new trans has is the...
Top Bottom
Back
Forums
Menu