Search results

  1. Lefty44278

    Oil in EGR Passage

    After putting my engine together and running it a while I noticed that there was oil coming from my air filter. I removed the intake tube and oil was pouring out. I then removed the upper intake and there was oil on the two mating surfaces between the intakes in the middle where I suppose...
  2. Lefty44278

    Fuel Leak from Rails

    I recently upgraded my fuel injectors to 42#'s. While I was running the motor for 15 minutes, fuel started spraying from the rails. The fuel rail seperated from the injectors (I have the areomotive fuel rails.) Could the fuel pressure be to high? It is set around 38 w/ a supercharger. Or...
  3. Lefty44278

    Cleaning Aluminum Heads

    What's the best way to clean aluminum heads? I am so use to clean cast iron so I was thinking of using a wire wheel w/ a dremel but i am afraid I will be taking aluminum off with the old gasket material. Should I go safe and use a scraper or is there a safe solvent to use?
  4. Lefty44278

    Water Pump

    I am currently trying to decide which water pump I want to put on my new block. I have it down to three mechanical pumps: Edelbrock Ford Racing Summit The prices for the three very form $80 to $180. Does the price reflect the quality? Do any of the pumps have a distinct advantage over...
  5. Lefty44278

    Blower Bracket

    My blower bracket sits in a little bit compared to the rest of the pullies, so the belt isn't running straight causing belt ware. I never noticed this before until I changed heads. Is there a spacer I could buy to bring the bracket forward to line up the pullies? I would make one, but it is...
  6. Lefty44278

    03 Cobra Rims

    I just want to know if these rims could fit on a fox with 95 spindles. I know they have a back spacing of 6.12. Also I heard they will stick out in the front, is this true?
  7. Lefty44278

    Rocker Stud Girdle

    Anyone know where I can find a 3/8" red rocker stud girdle? I don't know why I need red if it is covered by the vavle covers but I guess I want it to look good when I take pictures of the assembly for shows.
  8. Lefty44278

    What's a good 302 going for these days?

    I have a 302 with 30,000 miles laying around, which is all stock except for a B303 cam, windage tray, main stud girlde and a high volume oil pump in it. The engine is in great shape. How much do you think I can get for it? Would I get more if I put on a GT40 intake and 65mm throttle body, how much?
  9. Lefty44278

    Rear Main Seal Tool

    My rear main seal is leaking and I need to find a installer tool. I looked eveywhere around me and I found nothing. I found one for over $100 but thats pricey for a 1 time use. Does anyone know where one can be rented or purchased for cheap? Thank you
Top Bottom
Back
Forums
Menu