Search results

  1. Jsprint68

    Roof Wanted

    67-68 Coupe Roof Wanted I need a roof from a 67 or 68 coupe close to NJ. Has to be rust free and dent free. A small dent is ok as long as it is along the sides and not in the middle.
  2. Jsprint68

    Spring Cleaning!

    Prices do not include shipping. Parts will be shipped by whatever company you want as it’s your money. I recommend Fed-Ex ground, as it’s quick and usually cheaper than UPS or USPS. Small block Mustang frame mounts will fit 65-70 $50 + ship 67-8 6cyl SB trans cross member $15 Holley...
  3. Jsprint68

    Scam watch

    I just had someone answer a classified ad that said they were from Denmark. Something just didn’t set right with me and they finally showed their true colors. They were going to send me a check for $4k and I was to send$3500 to their shipper by Western Union. I was told that I would be able...
  4. Jsprint68

    Trade/Sell Holley 4412 2V for a 68 clutch pedal setup

    Holley has about 20 minutes of run time on it to demo an engine. The guy took the engine but not the carb. :mad: I need a clutch pedal setup for a 68. I need a power brake one but will take a manual. I will trade or sell the Holley. Clutch pedal setup or $150 plus shipping...
  5. Jsprint68

    What size bolt?----Toploader?

    What size bolts do I use to bolt the tailshaft to the insulator? The trans is a HEH-P and I see it’s a 64 trans that originally had the 25-spline output shaft. The bolts from the C4 are too big.
  6. Jsprint68

    Dust Boot for Hurst Shifter

    What has anybody used as a lower dust boot for a Hurst Completion shifter on their Mustang. I’m not sure if the stock ones for the Ford shifters will fit. I have a 68 coupe with a toploader and a 302.
  7. Jsprint68

    convert a 67-6cyl C4 over to a V8?

    Can I convert a 67-6cyl C4 over to a V8 by just switching the converter and bell? I could count the splines and figure it out my self but the two transmissions are buried in a back corner of the garage. If this is doable the trans will be used only for limited use until I get the V8 one rebuilt.
  8. Jsprint68

    6k or 8k in a 68 390 GT with a 4-speed

    I emailed Kevin at Mart Auto Works and he said that I should try posting this question on a forum. Which did the cars come from the Factory with? The Tachman said it would be a 6k but he wasn’t 100% sure.
  9. Jsprint68

    Lakewood Bell Housing Alignment

    I’m trying to align a 15200 bell on a 302 and well I can’t believe it’s off by this much. When I run a dial indicator on the crank and fly wheel I only get 0.002” fluctuation. When I run the dial on the inside the bore I get 0.018” fluctuation (I can get offset dowels for this). When...
Top Bottom
Back
Forums
Menu