Search results

  1. L

    Throttle gets hard after driving for a while...

    I have come to the conclusion that my throttle pedal is getting stuck after some driving. I mean is not stuck stuck but you have to hit it slightly harder than usual to accelerate. AFter it engages is smooth all the way until you release it and want to hit the gas again, you got to tap it a bit...
  2. L

    I need help connecting stuff to my ECU wiring...

    Im connecting a LC-1 wideband sensor to my car and Im looking for a switched 12V source in my ECU. I was told that pin #71 is the one to go for. I know where the ECU wiring is located (kick panel). I already have it opened, but how do I know where pin #71 is? Do I unplug ECU? How do I...
  3. L

    Throw out bearing location

    Hi guys, I have the little stupid squeaky noise coming from the #$%@$#$**@# TOB. I need to grease it up a lit bit and I was wondering where exactly is this bad boy? If Im not mistaken I have to work it out with lithium grease is this correct? I just need to know either by a picture or by a...
  4. L

    Trunk lights wont turn on...

    When I hit the breaks, the break lights do turn on, but the lights in the top of the trunk wont. I checked the bulbs and they are fine. One thing I gotta tell yall is that my ABS was replaced and that the Power Box (the one by the driver side, behind the battery) was replaced in the process...
  5. L

    Need advise on head install

    My friend just blew one of his spark plugs threads same as I did. This weekend we are going to take the head out and take it to a machine shop so we could get this fixed. Is there any step by step on head removal guides out there? I know this sounds stupid but I just dont want to f.u.c.k it...
  6. L

    How To measure TPS voltage...

    OK, I installed the Accufab TB/Plenum combo and the Steeda CAI (sweet mofokers), but my car feels like way too accelerated. THe way I checked the TPS voltage was putting a thin paper clip in the center cable from my TPS, I then went ahead and connected my ground from my voltmeter in a screw...
  7. L

    Misfire on Cylinder 3

    I have two codes that say that I have a: -P0316 Misfire Detected 1st at 1000RPMs -P0303 Misifire Detected in cylinder 3 What does this mean? Spark plugs are relatively new (only like 15-20000 miles), timing is at 10 degrees, I have not opened the hood in like 1 month and I have...
  8. L

    SES light coming on...need code reader

    I was wondering where to get a code reader for my car...stupid SES is coming on out of the blue...I was told to check in Discount auto parts...
  9. L

    Accufab Plenum/TB 75 or 70mm?

    Im thinking in grabbing one of these puppies but Im deciding between the 70 or 75mm one. Im N/A and on Nitrous when opened. Im gonna get my SCT flasher and Steeda CAI at the same time (holly **** my bank account is going down for good). 1- Ive heard people having problems at idle with a...
  10. L

    Installed FRPP Aluminum D/S...

    Please guys, if you swapped gears from stock to anything, and you are experiencing vibrations, shakes, driveline noise, DO NOT hesitate and get yourself on of these puppies. The D/S makes such a big difference, that you will be amazed. I could not engage 5th gear after going over 100MPH without...
  11. L

    Aluminum Driveshaft install after gears

    First of all, I would like to tell you to PLEASE put the gears tomorrow, dont wait, I dont care if you go 4.10, 4.30, 4.36 or even 3.73 just do it and find out by yourself, they make a huge difference on Nitrous or N/A. OK now this is the deal, I installed them recently and I've found that...
  12. L

    Shaking after gear install

    I had my gears installed a week ago exaclty, and I let them break in for about 250 miles. Gears are FMS 3.73's and they do not whine at all. The only problem is that going over 80-100 miles (not to say 120-130 like test driving them today) the car shakes like a little 2 cents whore. It almost...
  13. L

    Speedcal help...

    Im installing my speedcal after 3.73 install. I just need to know from any of you what cable color is the ground from the VSS cables? It says that is supposed to be the gray/red. I just need to know from the horses mouth which one is exactly, on a 2002 5 Speed GT. I left my voltmeter at work...
  14. L

    MSD Digital Window Switch install tips needed

    I just bought this and the instructions that came with it are not clear at all. I know that some of you guys here have installed it and I would like to know the "how to" on a '02 GT. Im using the NX wet kit and I would appreciate anything you can do to enlight me. TIA!!!
  15. L

    Original spark plugs replaced...is this a problem???

    I just replaced my original (36000) spark plugs (motorcraft platinum 32 something). When I took out the driver side sparks plugs all were "fine", did not have any color just if they were brand new. When I took out the passenger side all of them were white in the tip and some of them were more...
Top Bottom
Back
Forums
Menu