Search results

  1. green95gt

    Where's this oil coming from? Ideas?

    Hopefully someone can give some advice, I don't have any experiance with the 4.6 motor (i have a blown 95gt) My wifes 02 gt has started leaking oil on the right valve cover...but am only finding the oil on the top of the valve cover. And it only seems to be on the cover and in the bolt holes...
  2. green95gt

    Real Quick, where to connect tach wire???

    Installing my new tachometer in my 95gt. I can't figure out where to connect the signal wire to the coil. The one that actually reads rpm. the instruction were pretty good up until this and they say to connect to the negative wire. but when I use my test light it seems all wires going in are...
  3. green95gt

    Engine Knock, need advice

    My best friend has an 02gt with mild bolt ons (trottle body, cai, intake plenum ect.) About 70k miles. It has been well maitianed but recently started knocking around 3-3500 rpms. At first we thought it was from hitting his h pipe on speed bumps. But this weekend we had 2 mechanics tell him it...
  4. green95gt

    2 1/2 inch tail pipes-where to buy?

    I have flowtech shorty headers, or h-pipe, and 2 chamber flowmasters. I need a set of 2 1/2 inch pipes from the flows out the back. Anyone know the cheapest place to look for them?:shrug: I perfer them to have chrome tips. thanks in advance!
  5. green95gt

    Fuel Pressure help, please

    Help me set my fuel pressure I just finished putting in my 306. Can someone give me any suggestions on what to set fuel pressure with adj. regulator. I have iot set at 42lb now (I think that is the stock setting) I still have 19lb. injectors for now with the stock 1995 Gt fuel pump. Here is a...
  6. green95gt

    What to fill holes on gt40 Aluminum heads?

    There are a few treaded holes on my gt-40y aluminum heads. I'm pretty sure they are for emmisions stuff. Since my mustang has no emmisions equipment on it, does anyone know where I can find inserts for these holes? :shrug: Thanks in advance.
  7. green95gt

    need advice quick

    I am putting my shortblock together on the engine stand and I just noticed the exaust ports on my gt40 y heads are square. My headers have oval openings. Should I use square or oval gaskets. It looks as if either will seal it. Also, how bad will this mismatch hurt performance and sealing. Thanks...
Top Bottom
Back
Forums
Menu