Search results

  1. bchampion

    '67-68 Scott Drake Trap Door w/6x9 Speaker Pods

    So I purchased this from Holley, of course no instructions or hardware of any kind came with it. The only thing I see pre-drilled on it is for the latch, and it's obvious that the factory bolts on my current trap door latch will not work here, it will need self tapping screws. As for the...
  2. bchampion

    '68 Cooling System Problem

    So let's start at the beginning. Back in December I noticed a crack in my intake manifold where my temp sender screws in so time for a new intake manifold. Drained coolant and replaced intake manifold (like 4th time doing this) and while I was at it, swapped in a Cold Case aluminum radiator...
  3. bchampion

    No Brake Fluid to Driver Side Front Caliper

    So I finally decided to clean up my brake line setup as I got tired of how hodge-podge it looked even though it worked just fine. I have manual disc/drum setup. I ditched the factory block and manual proportioning valve and picked up a new distribution block w/proportion valve assembly from NPD...
  4. bchampion

    Ford Part# Needed-GT Hood Extractor Fastener

    Does anyone know the part# for the two clip fasteners studs & nuts that are used to hold the factory GT heat extractors in place? Thanks in advance,
  5. bchampion

    Fog Lights Mounted Behind Grill on a '67-'68

    Has anyone mounted fog lights, factory or aftermarket types, behind their grill for a stealth look?
  6. bchampion

    Spare Tire Question

    I recently purchased a 2015 Eco boost with the performance package for my daughter, and just like the GT performance, no spare. They can be found easily enough but they all have the disclaimer not available for cars with summer tires. For the life of me, I can't figure out why that would...
  7. bchampion

    Am I Reading This Diagram Right?

    The harness diagram below shows the 4 pin wiring option for 3 wire hall effect sender. The way I read this, the black wire from the sender connects to the Tan/Black from the harness, the white (sender signal) connects to the tan/white from the harness, and the red (power for sender) connects to...
  8. bchampion

    Problem With New Vintage Usa Performance Series Tach

    So I'm having a problem with the Tach that came with the New Vintage USA Performance series mustang DIY kit package. When I turn the ignition to power, the tach needle should jump, but all mine does is ever so slowly creep up to about 200 rpm reading and then stop. When I start the car, the...
  9. bchampion

    Highland Green Color Differences

    Can someone tell me the differences between the Dark Highland Green color of 1968 and the Dark Highland Green color of 2001, 2008-2009 model Mustangs? Paint codes are different. Looking at pictures, it appears that the 2001, 2008-2009 color is darker than the color from 1968. Thanks,
  10. bchampion

    '68 FB Rear Vent Removal

    So the time has finally arrived. I've saved up enough money to get my '68 painted. I'm getting all the exterior items off the car to save a few bucks in labor. This past Sunday I pulled off the interior rear quarters so I could get at the nuts for the exterior quarter panel ornament. I'd...
  11. bchampion

    '68 Sanden Idler Pully Adapter

    I'm looking for a close up pict of and installed idler puller installed using an adapter from a 3rd party vendor (classic auto air or old air products) when converting from a York style to the new style Sanden type compressor. Classic Auto Air has a 1967 or 1968 Mustang-Cougar Air Conditioning...
  12. bchampion

    '68 Rear Drum Problem

    Ok, so I've got everything on the rear shoes rebuilt and installed correctly, at least I think so. New shoes, cylinders, hardware, parking brake cable, & drums re-surfaced. But I can't get the drum to slide over the shoes. I have the adjuster all the way in (no threads showing), parking brake...
  13. bchampion

    ? About Gear Swap

    So Santa paid a visit and left me some gift certificates to MU. Well ever since I did the T5 swap about 2 years ago I've been dying for a rear end gear upgrade to ditch the 2.79 cogs I currently have in my rear end. MU has a master gear kit and a standard gear kit. Which one do I need? The...
  14. bchampion

    SLP Loudmouth Issue

    So I'm standing at the rear of my car doing something, don't remember what, but I noticed that my passenger side SLP Loudmouth is hanging lower than my drivers side.:( So I looked up under the car and notice that the weld that attaches the hanger to the tip has just about worked itself...
  15. bchampion

    Can't Charge A/C, Help.

    Well I finally got the a/c back together and installed in the car. So I pulled a vacuum, ok. I go to charge and I can't get it to suck any of the R134 out of the can.:mad::shrug:I check everything twice and it looks fine to me. High pressure (red) closed, low pressure (blue) open when...
  16. bchampion

    A/C Vacuum Motor Repair

    So 2 out of the 4 vacuum motors for my factory a/c are not holding vacuum, which is causing my woes. All my air is blowing out of my heater duct at the floor. So I have both of them off and they will not hold any vacuum what-so-ever. Is there a way to repair them and get them working again...
  17. bchampion

    '68 A/C Trouble Shooting ?'s

    So, it seems that no matter what setting I have the a/c controls in, the air blows mainly out of the floor ducts. Very little comes out of the dash vents and I can get nothing to blow out of the defroster ducts. Any ideas? Thanks,
  18. bchampion

    Need Help Finding Screw

    Can someone please tell me where the blower housing support to cowl panel screw is located? This is the last screw I need to remove so I can pull the heater/evaporator case out. 1968 w/factory a/c. Thanks,
  19. bchampion

    SLPs Too Loud for Wife

    So I installed some SLP Loudmouths on my '08 GT/CS Vert a few weeks ago. I love the sound they make and I'm not bothered by it at all. However; the wife thinks the car is WAY :mad:to loud now. So, I'm thinking about adding some resonators, say after the H-pipe, to quiet it down a little. Any...
  20. bchampion

    SLP Loudmouths In '08 GT/CS

    Got the Loudmouths in from Brenspeed on Friday and I put them on the car today. Hardest part of the install was getting the driver side factory muffler out. But, with the WD-40 and some persuasion, it finally came out.:nice: Install was easy as pie and the fit was fantastic. Now she really...
Top Bottom
Back
Forums
Menu