Search results

  1. P

    Ignition Tumbler Won't Turn oFF - Help please

    So my key ignition got loose and the car won't turn off. Made my way to the plastic rods that connect tumbler to the switch in the steering column. Well its the problem. First rod ( off the key ) is NOT connected to the 2nd inside the column. And the PIN is missing. I need to figure out the...
  2. P

    What did I do now? Ringing and smoking..

    Well.. I dont know if a ****ed something up bad or not.. but maybe you guys can shed some light...this is a 302.. Had a lean condition, especially 2k-4k Had a burnt MAF pigtail, removed that section and reconnected the harness. Installed a straight shot filter, incase the bends of a fenderwell...
  3. P

    Anyone cleared gt40 heads on stock 86GT bottom end?

    Ive read alot recently about the flat top pistons. Truthfully only way to know is to check the PVC. And probably notch the pistons.. But, some have commented they have been able to clear with E7 heads some with a small cam change.. TW heads will clear Ive read.. BUT, has anyone actually bolted a...
  4. P

    Aero Suspension a Direct Bolton for '85/'86 GT?

    Was noticing, while looking for suspension upgrades...alot of the MM or Aftermarket excludes the foureyes and only says 87-93.. is there something that must be changed when dealing with struts/shocks, control arms, braces, and or suspension mods??
  5. P

    Is a Clutch Release bearing suppose to be like this?

    I just got a new throughout bearing in the mail... M-7548-A Ford CL bearing Mainly because my last one was off centered and wobbled like heck.. if I held the large side and spun the smaller side. I thought it was busted. So I get this new one, and not to the same degree, but it is also...
  6. P

    W/ Smog Pump Out..Can EGR Still Work?

    I was wondering.. say someone deletes their smog pump.. Can the EGR still work? If you keep it hooked from manifold to Vac tree on pass. side.. and the back to the EGR...but cap the other vac line off.. Or is it all or none removed type of decsion?
  7. P

    Input needed on my vibration conclusion

    Ok so theres been a vibration in my car since we installed a new engine, for money and time reasons...we reused the old flywheel and cobra clutch and balancer.. everything was suppose to be 50oz setup. Vibration peaked at 4k rpms, was there with belt off, was there with it in neutral. Vibration...
  8. P

    Taking the Tremec out, did I miss something?

    Ive been in the process of dropping my tremec 3550.. well I got the transmission jack today and got up to the point of supporting the tranny, crossmember out of the way, disconnected speedo and sensors, D/S out...and removing two bolts on both sides, where the tranny meets the bellhousing. I...
  9. P

    Chk Engine Light, Did I melt pistons or Burn up starter??

    Replaced Calibration tube on MAF.. installed new spark plugs.... (after a cold start and alittle warming up..probably about 5-10mns) I set psi to 40. Timing was 12* Took it down the road about 2-3miles.. Later I checked over eveything and noticed a spark plug wasnt tightened enough.. doubled...
Top Bottom
Back
Forums
Menu