Search results

  1. M

    Powerdyne?

    Does anyone know what the difference between the 86-93 and the 94-95powerdyne BD-11a kit is. I know the pipe between the supercharger and throttle body will be different but is there anything else. Reason is I have one for a 86-93 and someone wants to buy it for their 94 if it would work...
  2. M

    TW heads and removing roller lifters?

    Does anyone know if i have to remove the trick flow heads to remove the lifter? Or can it be done with them still on? Thanks in advance>
  3. M

    36's or 42's

    which size injectors should i go with? i have a stock bottom end. kenn bell supercharger with 8lbs of boost and i am adding trick flow heads and an f cam. i'm thinking the 42's will give me drivability problem when not in the boost, but will the 36's be enough without an fmu. any help is greatly...
  4. M

    ACT sensor bad?

    getting a code 54, replaced with a new ACT sensor and still getting code. measured the voltage and got 4.72 from one wire. reference wire i'm guessing. and .10v from the other wire. all the info iv've read .60 is the lowest it should be. the temp here is high 70's and the engine temp was at 160...
  5. M

    kenne bell feul pressure setting?

    just got a 91 coupe with a s/c 9# boost(kenne bell) it has stock injectors (19#) maf and t/b. the feul pressure with the vacuum off is at 64# which seems really high vacuum on is around 50#. seems to run rich(black smoke and gas smell)it has the k/b fmu. feul preesure will go to about 80# with...
  6. M

    Does anyone know the part# for the WOT relay?

    None of the parts stores here can find i, even the ford dealer has no clue. It's the relay on the pass. side fender well w/ four wires going to it. It shuts the A/C compressor off when you are WOT. Mine kicks it off but won't let it come back on I have to disconnect it for it to send power back...
  7. M

    need help, out of ideas!!!

    my problem is when i'm over 3k and near WOT and up to WOT it will start missing. I changed the feul filter, plugs, feul pressure regulator, coil, had the TFI tested and good, ohm tested the wires and all are good. Can't find any vacuum leaks(checked with propane and also ether) Timing is good...
  8. M

    need help, out of ideas!!!

    my problem is when i'm over 3k and near WOT and up to WOT it will start missing. I changed the feul filter, plugs, feul pressure regulator, coil, had the TFI tested and good, ohm tested the wires and all are good. Can't find any vacuum leaks(checked with propane and also ether) Timing is good...
  9. M

    feul pressure regulator

    Does anyone know of an easy way to swap the feul pressure regulator. Tried earlier to swap it but ran out of time and had to put everything back together. :notnice: Can't get to the allen heads that hold it on except for one of them. All help and suggestions are appeciated. Thanks
  10. M

    code and WOT miss

    I pulled a 47 and 67 KOEO code. can only find out what code 47 is for KOER test. What does it mean for KOEO test? Also have a WOT miss above 3K. TFI tested good. When the puter is reset the miss goes away for about 2 days then it is back. That leads me to believe it's a puter controlled...
Top Bottom
Back
Forums
Menu