Search results

  1. 3

    Powermaster One Wire Alternator Hook Up Question

    So I am hooking up the wire to my starter since my starter relay is full of other stuff and my battery is back in my trunk. My question is should I run a inline fuse and will 8 gauge wire work since that's the size i already have . Also if I run a fuse what size fuse should it be thanks
  2. 3

    car getting hot question

    SO on my 94 gt mustang I only have a stock temp gauge in my car so I can't tell you exactly What the car is running at but here is my situation. While I was driving the temp would move about 20 degrees from normal to to hot fluctuating like that for the whole trip. So I put in a new thermostat...
  3. 3

    fuel filter question

    It seem that my fuel filter was on wrong from the previous owner. I'm surprised the car ran ok. Anyone else ever have this happen? By wrong I mean the flow arrow was pointed towards the tank.
  4. 3

    oil on plugs

    How worried should i be having some oil on my plugs on a 98000 mile motor. I don't beat on the car to much will the motor still last a while or should i be shopping for a new one.
  5. 3

    spark plug question

    I changed my plugs and noticed some of them were wet. Would this be probably oil blow-by or could it have been fuel that didn't burn off? The motor has 98000 on it.
  6. 3

    TRANSMISSION QUESTION

    sO iT IS BECOMING HARDER AND HARDER TO SHIFT. iS THIS MOST LIKELY A TRANS SHIFTER OR CLUTCH PROBLEM . i WAS THINKING TRANS BUT HOPING NOT.
  7. 3

    Iac question

    So i tried to mount my iac upside down to achieve better start ups. the problem is when i flip it the wire harness hits the tube coming of my egr spacer. what am I doing wrong?
  8. 3

    x-pipe or msd

    Based on my mods listed below which do you think my car could benifit from more an of road x pipe or msd 6al box? Other suggestions are welcome my budget is around 200
  9. 3

    +exhaust adviced needed

    So I have a mostly stock 94 gt. The cats are going on it and I'm thinking of doing an off road x pipe and shorty header, on a budget. Summit racing sells a shorty header for 100$ and an x -pipe for 165$. Has anybody heard anything good or bad about them.
  10. 3

    spark plug question

    What would you recomend for my set up. Everythings listed below.
  11. 3

    car dies /runs bad when cold

    So when I go to start my car it always starts then dies within a few seconds. Than i'll start it again and it will run, but untill its warmed up it runs like crap. Alot of sputtering. Any ideas of why?
  12. 3

    heat spacers worth it?

    I was thinking about getting a heat spacer between the upper and lower intake. I was going to do this since my upper intake gets so hot. Think its worth it? Anyone have any good or bad experences with them?
  13. 3

    rear controll arm bushing question

    I can I tell if the bushings are bad.? Is it something I would be able to see or is there some sort of test? Thanks
  14. 3

    wheel hop question

    So I put on the slicks today and experenced wheel hop. Something I didn't experience with my other tires since the didn't hook worth a crap. I have mac lowers 50/50 shocks and 91/10 front struts. Would a good pair of uppers take care of the problem. The wheel hop is not terrible but would like...
  15. 3

    new gas tank installation question

    So my old tank had material on top so the tank wasn't hitting the car the new tank is just metal on top . My question is should I put on some insulating tape or something so the tank is not hitting the car (metal to metal ) or don't you think it matters? Thanks
  16. 3

    fuel pressure question

    So I did ask this before but am looking for some new suggestions. When I give my car some throttle the fuel pressuse drops about 4 psi I have a new tank and lines new 190 pump new sending unit and new 24lb injectors. Does any know why the pressuse would drop. It doesn't drop and come back up it...
  17. 3

    I installed a new fuel tank and now...

    So I installed a new fuel tank, fuel lines, and sending unit. The pump is only a year old. The weird thing is that when I turn the key the pump doesn't make any noise like it did before when i would turn the key into the on position, but the can started up ok. Anyone know why all of a suddun the...
  18. 3

    lower torque box reinforcement question

    So today i was putting on my lower controll arm torgue box reinforcements. The bolt that holds on the lower controll arm was surprissing loose. Not finger loose but it broke loose pretty easily. My question is how tight should that bolt be put on is there a torque spec? Can it be put on to...
  19. 3

    air/fuel meter question

    Is it worth an extra 200$ to get a meter with 2 o2"s , one for each side or should I just save the 200 and get a single 02 setup
  20. 3

    Where to buy fuel lines

    Does anyone know where I can get the 2 rubber lines that go from the tank to the hard line. Do local parts stores carry .it ? If not where can I get thosae lines without buying a whole new fuel system thanks