Search results

  1. Hi-Po

    5.0 theoretical top speed?

    Here in Norway the highway speed limit is 100 km/h (roughtly 60 mph or so), and violators are likely to get stoned to death or jailed and fined so they will be impoverished for the rest of their miserable lifes. :( So, in that respect I am curious - what is the theoretical top speed for a bone...
  2. Hi-Po

    Traction-Lok rebuild kit

    My diff is getting tired, and I noticed 5.0 Resto is offering this kit which says it will upgrade the stock Traction-Lok to 03-04 Cobra specs. http://www.latemodelrestoration.com/item/M4700C/Mustang-88-Traction-Lok-Rebuild-Kit-with-Carbon-Discs Has anyone here tried this kit? How...
  3. Hi-Po

    Need clutch advice

    I will probably need to replace my clutch in the near future, and would much appreciate some advice on which clutch to get. I have been running a FRPP King Cobra clutch for the last 8 years or so - and although it has done a good job I would like to get one that gives better driveability...
  4. Hi-Po

    FRPP King Cobra clutch

    Not sure if this should go under tech or talk, anyways here goes. For those of you who have experience with the King Cobra clutch, up to what powerlevels are they good, and what kind of durability can I expect? I have been using one for the last 8 years and approximately 60,000 miles -...
  5. Hi-Po

    More friggin codes

    Right.. My car hesitates under acceleration, and fuel consumption seems high. It starts easily enough when both cold and warm, but has a very low cold idle 400-500 rpms compared to 720-760 when warm. During ordinary cruising everything seems fine though, but when trying to accelerate nothing...
  6. Hi-Po

    Starter problem

    My starter does not disengage when the engine starts, it just keeps on turning. :mad: The only way to stop it is to put the car in gear and release the clutch while standing on the brakes for at least 10 seconds. Any ideas/tips please?
  7. Hi-Po

    Door hinge bushings

    How hard is it to replace the door hinge bushings? How is it done? My driver side door is sagging :(
  8. Hi-Po

    VC oil baffle removed - consequences/options?

    First of all - I have searched both this forum as well as Corral but the info I am finding frankly just makes me more confused. Anyhow, I have removed the oil baffle in my pass side valve cover to get clearance for my roller rockers. As per now I have hooked up again the tube from the oil...
  9. Hi-Po

    No CEL, but getting Code 66

    So my car is finally running as I think it should after my cylinder head swap. I am not getting any check engine lights anymore, but when checking for codes today I got code 66 - "MAF circuit below minimum voltage". It is a brand new MAF from Summit - Summit SUM-29052B-C - Summit® Mass...
  10. Hi-Po

    Fluctuating fuel pressure?

    So.. for a long time now I have been somewhat uncertain about my fuel pressure. See sig for specs/mods. Occasionally my Kenne Bell in-car fuel pressure gauge has showed sudden drops/fluctuations in my fuel pressure, falling from approx 39 psi down to 30 or 20 or even 0 and then up again...
  11. Hi-Po

    Oxygen sensors - Code 41

    How can I test/check my oxygen sensors (HEGO)? I replaced them maybe three-four years/approx 20/25,000 miles ago - and now I am getting Code 41 - "No HEGO (H02S*) switch detected - always lean (right H02S) Just installed new heads/roller rockers/lifters/pushrods (Trick Flow), throttle...
  12. Hi-Po

    New stuff - start then no start - code 96 - help - jrichker?

    Sorry bit long but please read - need help with a start problem: I have finally completet the installation of the following new parts: Trick Flow heads and roller rockers pushrod lifters Summit MAF calibrated for 30 lbs injectors Trick Flow 30 lbs injectors Edelbrock 70 mm TB and...
  13. Hi-Po

    92 LX - Codes 67 and 79 - Need some help please

    I did a KOEO scan today and came up with two a/c related codes - 67 and 79 According to the scanner: Code 67 - A/C on during KOEO or neutral drive switch open or manual lever position sensor out of range or neutral pressure switch closed or Park / Neutral switch open. Code 79 - A/C or...
  14. Hi-Po

    Maximum Motorsports LCA's

    Posted this by mistake under Talk, so here goes: Both my upper and lower rear control arms are on their last legs and need replacing. I have decided to go with Maximum Motorsport non-adjustable arms but I am not sure whether to go for the heavy duty lower arms or the extreme duty. My car...
  15. Hi-Po

    Maximum Motorsports LCA's

    Both my upper and lower rear control arms are on their last legs and need replacing. I have decided to go with Maximum Motorsport non-adjustable arms but I am not sure whether to go for the heavy duty lower arms or the extreme duty. My car is a daily driver year round, but it is also my...
  16. Hi-Po

    Piston to valve clearance on aftermarket heads

    Do all aftermarket heads with 2.02 intake valves require you to notch the pistons for clearance when running a stock camshaft?
Top Bottom
Back
Forums
Menu