Search results

  1. 9

    backfiring, need help!

    Just finished the carb conversion on my 91 GT.. Got initial timing set at 10*..Set idle & fuel mixture, float level & fuel pressure is at 5psi.. I'll probably bring it up to 6psi though.. Anyway, when I have the vacuum advance plugged on the distributor, the motor runs great.. If I connect...
  2. 9

    Need Help! Car wont start after Carb Conversion...long

    Did a Carb & T5 conversion on my '91GT. Installed an MSD 6A w/ blaster 2 Coil, '85 GT dizzy, performer 289 intake, brand new Holley 600 Carb, Holley Blue pump w/ Mallory Bypass Regulator.. Removed computer, harness & smog.. What is happening is I am getting popping/backfiring from the...
  3. 9

    Help! Car wont start after carb/T-5 Conversion!!

    Like subject says.. I did a carb conversion & T5 conversion at the same time on my '91GT.. Got everything all buttoned up and went to start it and it wont start.. Starter wont turn over.. Here's what I did.. First, charged the battery.. Interior lights work.. as well as wipers, radio...
  4. 9

    Mallory Bypass style regulator

    I bought this regulator to use for my carb conversion.. I am going to be ready to start the car for the first time in a day or two.. I was just wondering how you set the fuel pressure with this regulator.. It is the bypass style regulator.. I am running a Holley Blue pump.. I lost the...
  5. 9

    rearend trouble

    I replaced my rear brakes the other day and after i was done I spun the wheels to make sure they werent adjusted too tight.. THe wheel on the passenger side was locking up when I spun it.. As if I had the car in park.. I would spin it(by hand), it locked, I back off, then spin again and same...
  6. 9

    Question for guys who have done carb conversion

    I am in the process of finishing up a carb conversion.. I have a 91GT.. Removed the computer & engine harness, all EFI stuff, A/C, and Smog.. Installed a edelbrock Performer 289 intake, New Holley 600cfm carb, Distributor from an '85GT, MSD 6a & Blaster Coil, Mac Longtubes, no-name X-pipe I got...
  7. 9

    Need Help with T5 conversion

    Hey guys. I'm new to this message board.. Hoping I can get some help here.. I have a '91 GT. Originally had an AOD trans and I swapped in a T5 I got from an '86 GT that had been crashed.. I did all the mechanical stuff, no problem.. What I need help with is the wiring.. The T5, being...
Top Bottom
Back
Forums
Menu