Search results

  1. MTLBLKNOTCH

    full length or shorties?

    Full Length 100% but I would go with the BBK ceramic coated as they are an awsome set that look awsome for some time after the install. Just be sure to clean them off before starting the car as the oil from your hand will burn into the finish if you don't. Sean
  2. MTLBLKNOTCH

    One Last Problem and she's ready

    So I am geussing this isi not a comin problem when people do mass air conversions.
  3. MTLBLKNOTCH

    One Last Problem and she's ready

    No other ideas from anyone? I will be checking the readings of the TPS key on engine off tomorrow to see what happens with the voltage as I press the clutch. Sean
  4. MTLBLKNOTCH

    Oil weight ... what to use?

    Mobil 1 20w50 or 15w40 This is what I have been using for the past few years now and it's great. Sean
  5. MTLBLKNOTCH

    One Last Problem and she's ready

    I have both the last scanner you posted and the Ford Rotunda scanner from the dealer. I have yet to scan for codes as before I found the short to ground in the nuatral switch I was not able to scan the car.
  6. MTLBLKNOTCH

    One Last Problem and she's ready

    No no the car starts on every try, the problem is that when I start the car the rpm's are very high and after they settle down if I press the clutch and release the car dies.
  7. MTLBLKNOTCH

    One Last Problem and she's ready

    No no the car starts every try, but when it does the rpm's are over 2500 and when I let go of the clutch the rpm's will drop to about 1100 and once the car is wormed up they are at about 800rpm. The problem is when I touch the clutch after the car is running and let it go again the car then...
  8. MTLBLKNOTCH

    One Last Problem and she's ready

    Ok since my last post in the last few months I have changed the complete harness in my 88 LX to one from an 89 with the A9L computer. This worked great as the car starts great now but I have come to find one problem. I was not able to start the car after it was running for a few mins, I then did...
  9. MTLBLKNOTCH

    88 LX Running problem!!!

    No one has any idea's ???
  10. MTLBLKNOTCH

    88 LX Running problem!!!

    I started my day off today by changing the 190l/ph pump out for the stock unit, this did seem to help as the car started well and was a bit smoother. Then when I was just about to set the timing it died and it was time for break. I came back to the car after and she would not start, so for half...
Top Bottom
Back
Forums
Menu