Search results

  1. J

    more junkyard engineering... (reclining stock Mach 1 seats)

    thanks for the memories.. I just had to comment that one of the first mods I did to my non-Ford car was make the front seats fully recline. I did this by enlarging the hole the original bolt pivot went in and put in a sleeve and then slotted the hole and welded an extension onto it. To...
  2. J

    5.0 Swap Wiring Harness Mod Question

    no problem, I moved the glovebox out of the way so I could get in there, and indeed the area where the heater fan wire goes there is clear right above it. Just big enough to get the stuff in there. Got the wiring all done taped up and installed and engine running. But somehow today when I...
  3. J

    5.0 Swap Wiring Harness Mod Question

    Bullitt, is this the spot where a wire from the fan motor goes into the firewall? I fired up the motor today, fired up on the first try! Now I just need to tape up and wire loom the wires and run them inside the car. How do you fit the control box through the grommet hole?? Jack p.s. just...
  4. J

    and thus he bangs his head on the wall...

    I think the rear main seal if the rope kind can make the crank not spin freely, but it should spin...
  5. J

    5.0 Swap Wiring Harness Mod Question

    5.0 EFI Wiring Harness Info / Firewall Grommet Hello, I'm right in the middle of finishing up my 5.0 HO EFI conversion on my '70 Mach1, and I'm doing the wire harness right now. I'm using the stock harness and modifying it. It has been confusing, but I think I've got a handle on it now after...
  6. J

    5.0 EFI Swap Vaccum Lines question

    Hello, I've put a '89 5.0HO in my '70 Mach1, and have been working on finishing up the conversion. I'm confused on where to run the vaccum lines. No problem with the fat one that runs to the brake booster, but the question is the small ones. They are a few that connect into a round barrel...
  7. J

    AOD trans cooler line fittings

    Hmm, there is a plastic sleeve around the tubing in the fitting, it sounds like these fittings go into the radiator and not the transmission!? Must be why they don't seem to fit right! I don't have other fittings that go into the trans, can these be bought new or are they junkyard items...
  8. J

    AOD trans cooler line fittings

    Are the cooler lines coming out of the AOD trans supposed to be loose? The upper tube can move around, the lower one seems firm. I'm confused if this is normal for the AOD, it is certainly different than the older trans that I'm used to. thanks, Jack
Top Bottom
Back
Forums
Menu