Search results

i did that and when i removed the coil wire from the distributor and grounded it on the post it fired and started. The other time it wouldnt start i pulled the #5 plug wire off and grounded it on a bolt and then it started again. I think it may be the distributor but its fairly new so i didnt...

Yeah that might help. Its a stock 1990 mustang gt except for headers/pipes/mufflers. Now im scared to drive it because it might leave me stranded:nonono:

Hey its been awhile since i posted anything, my cars have been running good until the other day. Now heres what happened. It wouldnt start so i checked to see if it had any spark by using an old plug and it didnt have any then i pulled the coil wire off the dizzy and grounded it a bolt and it...

anyone?

well i tried the water at night but my car fired right up every time and i didnt see anything suspicious. My car has ran fine until yesterday and it did the same thing again. Heres what happens: I drove to the store and the car ran fine and strong. When i came back out to leave it fired right up...

Heres what happened. I took my little boy to school the other day and walked him to the steps and when i came back out my car wouldnt star (its a 90 gt mostly stock) It turned over fine but would not start. It was pouring down rain so i went home to get some tools and i went back after the rain...

86 should accept roller lifters. I think they went roller in 85

I would clean the maf like they said and have a look at the plugs/wires. You might even have autozone test the dist. module.

:worthlesb of said girlfriend

check your swaybar endlinks while you're down there:nice:

A guy at work the other day came up and asked me if i knew where he could get a seat belt for an 86 saleen mustang. He said he didnt mind the color, he just wanted to get it on the road. I told him i wasnt completely sure but he could prolly get on from a junkyard. He said he was told that it...

I came across a distributor a friend of mine said i could have but i dont know if i can use it. My car is a 90 gt and the distributor says on it motorcraft e4ze-12131-aa. Can i use this distributor? Im not sure what car it came out of. Does anyone have a pic or a part number for a factory...

does the rotor button actually touch the posts on the cap when it turns? My posts have grooves cut in them where the rotor button point is hitting them. They are kinda covered with a flaky substance too.

no the guage only drops a 1000 or so. It does it very quickly while im cruising. What is a cps?

well it finally warmed up here and i plan on doing the hci swap but my car still has the strange miss every few days. It will start up fine and idle and it will run great for days, then out of the blue just crusing along the rpms will bounce down quickly and the car will start jerking. (it...

yes, im talking about carbed intakes. The reason im asking is because ive seen some intakes that say they are "high rise design" and ive heard the term used before, but these intakes dont differ much from any other intake ive seen, Whats so special about them?

how can you identify a "high rise" over a normal intake? What are the major differences? Are there any visual differences? thankx.

Dont forget to take a pic of the neeldes before you remove them so you can put them back exactly like they were:nice:

maybe i should just get the 1.6s

No, i mean suppose the valves hit