Search results

Anyone know the new code spending almost 400 today

i love these wheels and i am leaning on buying them i know it probably has been covered but before i spend money on wheels and tires i want to be absolutely sure i won't have any rubbing issues.my question without rolling fenders and best look what tire size look best and won't give me a...

Will try to post a link

Will try to post a link

the center brake hose on my rear 95 gt rear end doesn't mate with my stainless 1987 brake line what fitting have you guys gone with?

my car is an 87 mustang and i bought an aluminum driveshaft for it a while back looking to install this and was wondering which way the yellow sticker goes up or down?the rear end isn't original to the car so i am trying to do this without getting the vibration that people complain about.my car...

with all the spark plugs in and turning the crank i am hearing a noise coming from my clutch area of my trans .i am having a hard time turning this thing over a turn and it seems to come to a stop.i didnt try to do this with all the spark plugs removed and no compression.this motor has been...

Are these the Same as the 87-93 mustangs having a hard time finding the female fittings that snap into the stainless male lines after the fuel rails.these are typically nylon with rubber hoses over them like the returns to the tank.or does anyone know where I can find these ?

Are these the Same as the 87-93 mustangs having a hard time finding the female fittings that snap into the stainless male lines after the fuel rails.these are typically nylon with rubber hoses over them like the returns to the tank.or does anyone know where I can find these ?

Any idea where I can find these and will the explorer ones work and of so what year?

Looking at the directions they are not clear where the spacers go ?i know one on each side but on the axel or the body ?

should i just use the gaskets that came with my bbk equal length headers or use the permatex high temp silicone.also will this clear my strut towers or should i just drop the motor in and then install the headers?i have the maximum motorsports steering shaft .

any idea where i can find some the ones i have are too short trying to button up this motor so i can drop it in.

the motor that is going in my car is rebuilt but the guy i bought it from had thrown a carb on it.i am curious do i need to swap out the cam since i am going back to fuel injection with this motor?also,for a fairly stock setup if i do need to swap it out and being it has stock heads and all what...

i picked this up a year ago and i need the pressure plate ,throw out bearing and pilot bearing i want to make sure i get the right parts for this clutch you guys know which one is compatible? pressure plate part number?

i installed the rears but the fronts are a little bit tricky without the weight of the motor.i rented a spring compressor from autozone but that didn't work too well.what have you guys tried to remedy this problem?

i just picked one up locally still brand new never been painted but unfortunately it was drilled out for hood pins.i am not a fan of the hood pin look but i understand the safety aspect of it.i did have a hood fly open on me back in the day not fun.has anyone tried to fill those holes in and if...

i read that the pink ones i have are 21 pounders where would i go to calibrate mass air to match?

i have two and i guess there are three different ones i think my harness is from a 92 and i am hoping my harness is from a 93 .what are the differences that i need to be aware of to see if it will match?

just curious if anyone has ever swapped out the front end of a 94 for the 87-93 or four eye models i know the moldings don't match .i have never been a fan of the 94-98 front ends.i know that the foxbody cars 79-04