Search results

  1. Shrimp300

    TC not always engaging....

    when I start to accelerate my check engine light will come on, as I drive for a little bit the TC will finally engage and the CEL will turn off, and for the rest of the trip the light will not come back on. ex: I was driving today going 75 running 3000 rpm after about 10 min the TC engaged and...
  2. Shrimp300

    high idle/no heat

    recently my 93 has started to idle at 1300 and the heat no longer works its like it is stuck in the warm up phase just after startup WTF is causing this?:shrug:
  3. Shrimp300

    Major A4LD Fluid LeaK....

    My 93 is dumpin alot of tranny fluid between the dust shield and bellhousing. I had forgotten to plug in the EEC connection for the tranny when i replaced the rear main seal, before it was connected there was no leak. Once plugged in and the TQ clutch started engaging again the tranny started...
  4. Shrimp300

    A4LD No OD?????

    i just got done replacing the rear main seal in the car. I hooked everything back up but I now have no Overdrive for some reason. The tranny wasn't taken apart just removed from the car and then reinstalled. Any thoughts what the problem could be????????
  5. Shrimp300

    347 or 351????

    I am starting with an 89 coupe 4 banger and converting it to a strip/ street car mainly a strip car. Which motor should I run a 347 or 351. I plan on runnin a blower or centrifugal not to long after the build. I guess CHP is a good company to go with. ANY THOUGHTS?????
  6. Shrimp300

    347 or 351???

    I am starting with an 89 coupe 4 banger and converting it to a strip/ street car mainly a strip car. Which motor should I run a 347 or 351. I plan on runnin a blower or centrifugal not to long after the build. I guess CHP is a good company to go with. ANY THOUGHTS?????
  7. Shrimp300

    Cougar 8.8" rear swap Q's....

    I'm in the middle of a 2.3 to 5.0 swap right now but I have a got a question concerning the rear end. Will an 88 cougar 8.8" rear fit in an 89 stang? I know the rear has 10" drums and the brake lines connections are a little different other than that, Will it work? Thx