Search results

  1. R

    96 explorer Trac Loc work in 95 Mustang?

    He said they are 31 spline. :notnice:
  2. R

    96 explorer Trac Loc work in 95 Mustang?

    I found a guy locally selling 8.8 Trac Loc and axles-3.73 gears from a 96 Explorer. Will this work with my 95 mustang GT? I have a lincoln locker now. I do not know if the splines are the same. Or if there are other differences or not.
  3. R

    How rare was the red interior in the 94-95 cars

    Not rare enough in this stanger's opinion. But to each their own.
  4. R

    Oil leak, but from where?

    I have noticed oil is leaking on my exhaust at the firewall. The whole underside of the engine from the oil filter to the driveshaft is wet with oil. the top and sides of the bell housing are dry. I opened the window/cover in the bell housing and the torque convertor is totally dry. I replaced...
  5. R

    Eaton M90 95 GT (in works)

    I have a 2.3" pulley (took your advice) 7 PSI. If I unplug the chip the timing is at 10 deg. The guy who tuned it said that he had to pull 16 deg of total timing.
  6. R

    Eaton M90 95 GT (in works)

    Vented drivers side and NO DIFFERENCE. I am starting to loathe my car!
  7. R

    Eaton M90 95 GT (in works)

    The chip causes intermittent start up problems. Sometimes it works fine though. I just realized that I blocked off my pcv and I only put a breather filter on the top of the passenger side valve cover. I read in another forum that could cause crankcase pressure and blow by resulting in...
  8. R

    Eaton M90 95 GT (in works)

    I do not know what the a/f was. I also do not know what the final timing was set at. I went to start the car yesterday and it turned over many times and no start. This morning I pulled the diablo chip out and it started right up. I put it back and it woyuldn't start again. Pulled it out and now...
  9. R

    Eaton M90 95 GT (in works)

    I forgot to mention that somewhere in the back of the engine there is an oil leak. Oil was burning off of my exhaust near the mufflers and a light cloud of smoke was coming somewhere in the back of the engine. The valve cover on the passenger side has a decent amount of oil on it. I do not see...
  10. R

    Eaton M90 95 GT (in works)

    Disappointment at the DYNO. I ran my best at 205hp and 283 torque. The guy who tuned said I need new spark plugs. Mine are still original. He said that he had to pull too much timing to get it to not detonate. I was commended for my efforts by everyone who worked there. The owner of the shop...
  11. R

    Oil Change Problem?!

    Thank you. I am sure that seems like a silly question to most of you. I have changed oil in many cars and I have never seen one with 2 oil plugs. Job Done
  12. R

    Oil Change Problem?!

    I have drained all the oil from my car and removed the oil filter. 3 quarts came out roughly. I cleaned the dipstick and put it back in and it reads full! I did this several times with the same results. The car is on level ground. What the hell could this be from? And, should I put 5 quarts back...
  13. R

    Eaton M90 95 GT (in works)

    Runs Very good. I had a few small issues but they are all sorted out now. Need a boost retard badly!. I have the timing set at 1 degree and it still detonates at high RMP. I have 7lbs of boost. I have an appointment to get it Dynoed and Tuned on Saturday. Hopefully this will help. I will post...
  14. R

    Eaton M90 95 GT (in works)

    The alternator is where the smog pump was located.
  15. R

    Eaton M90 95 GT (in works)

    DONE, IT RUNS I finally figured out the problem. Somehow, in the process of putting this S/C on my car The #4 fuel injector came unplugged. Now it runs better. It is only hitting 3psi with the stock pulley. I need to get the smaller pulley and a tune still. But, WOW what a difference! The car...
  16. R

    Post pics of stangs gone horribly wrong

    Here is a link to another forum with the same principal. http://www.moddedmustangs.com/forums/strange-and-ugly-mustang-contest-vt1541.html
  17. R

    Eaton M90 95 GT (in works)

    I did not receive the email. [email protected] Thanks for your help!
  18. R

    Eaton M90 95 GT (in works)

    The hood only needs to go down like 1". I may just chop the 1" off the S/C top piece made. Or buy an older Eclipse hood. Just Kidding! frustrating day. My neighbor said he can weld the part that broke on the idler. My welder is only flux core and will not work. I'm sure it will all work out...
  19. R

    Eaton M90 95 GT (in works)

    Intake manifold gasket was leaking. Idle problem fixed. 2 minutes after getting it to idle ok the stock tensioner pulley cracked it's housing. :( I can either find another stock one or fab one on my own. I still have not figured out how I am going to extend the throttle cable yet. And worst of...
  20. R

    Eaton M90 95 GT (in works)

    Lumpy Idle Since I installed the s/c my idle is very lumpy. I still have stock cams. I also noticed that my check engine light has come on. When you hit the gas it goes just fine but the idle is irregular. Could this be because I have not had it tuned?
Top Bottom
Back
Forums
Menu