Search results

  1. 2

    2000 Cobra R rear end

    Hey, is there a difference in the Cobra R rear end as opposed to the 2000 Mustang or 2001 Mustang/Cobra? I have a knock in the rear end when turning sharp right periodically and trying to find a manual so I can look into it. Thanks
  2. 2

    Good Vendor/ Bad Vendor ???

    NPD by far!
  3. 2

    Resistor wire Ohm's

    Thanks for all the info. I think i'm getting there!
  4. 2

    HELP! NO FIRE TO DISTRIBUTOR 351C

    I think my problem is the resistor wire going to my tach.
  5. 2

    Resistor wire Ohm's

    Can anybody tell me how many OHM's the resistor wire that runs from my coil to my tachometer? The car is a 1970 mach 1 with a 351c.
  6. 2

    HELP! NO FIRE TO DISTRIBUTOR 351C

    Everything is new.
  7. 2

    HELP! NO FIRE TO DISTRIBUTOR 351C

    Hello. I have a 1970 351C Mach 1. I cannot get it to fire. It has a Mallory dist. I have voltage going to the coil from the two post but not out of the center of it. Does the voltage go thru the coil to the dist and then back thru the center of the coil? I have changed out the dist. and coil. I...
  8. 2

    Carpet for a 66 - Where to buy - best quality

    NPD, NATIONAL PARTS DEPOT HAS GOOD GRADE CARPETS.
  9. 2

    70 MACH 1 HAS NO FIRE!! HELP

    Check all that. I think there is a resistor wire running to the tach. Could this be my problem?
  10. 2

    70 MACH 1 HAS NO FIRE!! HELP

    Thanks 69. I've reset the timing TWICE. Replaced the MALLORY electronic dist. I am getting gas. I've checked my battery,coil, ignition system. I know that i'm ok from the ignition to the coil and battery. It seems that i'm getting fire to the dist. but not out. I even pulled the #1 plug wire and...
  11. 2

    70 MACH 1 HAS NO FIRE!! HELP

    Can't get my Mach 1 to fire? Tried everything. Where and how to start to troubleshoot it?
  12. 2

    REPLACING DISTRIBUTOR IN 1970 351C

    Thanks PB, I'll try that!
  13. 2

    REPLACING DISTRIBUTOR IN 1970 351C

    PLEASE HELP!!!
  14. 2

    REPLACING DISTRIBUTOR IN 1970 351C

    Thanks. Why do I need to turn it if I am just pulling the old one out and replacing it with on just like it? I marked the rotor and dist. on the block.
  15. 2

    REPLACING DISTRIBUTOR IN 1970 351C

    Hello.I am trying to replace the dist. in my 351C motor. Any neat ideas on how to deal with the oil pump shaft that runs to the bottom of the dist? I am having a heck of a time trying to get them to line up!
Top Bottom
Back
Forums
Menu