Search results

  1. ALMOST STOCK

    Foxbody Driver's Seat Issues---Need Advice

    You might check here , this was the problem I had.
  2. ALMOST STOCK

    Engine Correct Gap For 1991 Mustang GT With Motorcraft Plugs

    SPARK PLUG GAPPING Ford Suggests .052--.056 autolite 24's gap (factory setting) .054
  3. ALMOST STOCK

    Engine AC bracket paint colors?

    Chrome not painted.
  4. ALMOST STOCK

    Steeda Firewall adjuster

    I stop by 3 or 4 times a year to see what's going on. These are the most recent pic I have and there 4 yrs old
  5. ALMOST STOCK

    Steeda Firewall adjuster

    Hope it shows how it fits the firewall.
  6. ALMOST STOCK

    Post pics of how your foxbody currently sits

    Thanks everyone for the complements I really appreciate them. mikestang63 I had no idea it's been that long I'll try to stop by more often.
  7. ALMOST STOCK

    Removing Front Struts, Help

    Don't worry about the springs they won't go anywhere believe me. I did exactly what your asking over 14 years ago by welding all the holes and smoothing the engine bay. I removed the engine, trans, struts and steering rack and there was never a problem in doing so. The only problem...
  8. ALMOST STOCK

    Where Can I Get Water Pump Bolts / What Are The Sizes?

    I was asked by a friend if I could post this since it's not often I post here any more. TIMING COVER and WATER PUMP bolt length and locations All bolt measurements are measured from the underside of the bolt head to the end of the threaded bolt. All of these bolts are torqued 12-18 Lb-Ft All...
  9. ALMOST STOCK

    Pictures Of Stangs On Different Wheels Than Typical

    A lot of great guesses but wheels are SSR:). 85_ SS_302_COUP you should know that better than any one else:rlaugh: http://www.stangnet.com/mustang-forums/threads/maximum-motorsports-17x9-konig-wheel-on-a-fox.703448/#post-6926190 Thank you all for the complements.
  10. ALMOST STOCK

    Torque to Yield....what an unnerving procedure

    As stated by Jrichker the 1989 Mustang Shop Manual says to use the 2 step method to torque the cylinder head bolts. This is from my 1989 Ford Mustang Shop Manual which hopefully the Ford ASE Technicians use and not the Chilton or Haynes Manual.
  11. ALMOST STOCK

    Heater Coolant Tube Leaking on Lower Intake

    Being the original owner of my 89 and when polished all the aluminum parts on my engine I had my heater tube chromed I don’t ever remember seeing any O-ring on the heater tube (between the upper and lower nut or any where else), and I never installed an O-ring when I reinstalled the heater tube...
  12. ALMOST STOCK

    Are AFR 165 too much for gt40 intake?

    Thank you very much for your complement, and believe me there was never any intentions on my part to derail your thread I only responded to clarify the accusation that my upper/lower and brass sensors were either chrome plated or chrome powder coated and nothing more but since you asked. What...