Search results

so I found this vehicle on CL. it had sat and rotted for roughly 11 years. engine did still start but smoked allot. Had a T5 conversion. interior and exterior paint was sun burned as well. brake fluid had gelled up in most of the lines. Tires were trash as one would expect. had after market 14...

ive inspected the teeth several times, even removed it to check it and compared it to a new one and still looked fine

ive replaced and checked all grounds under hood as well,

yes that was also installed as well, and i also jsut noticed somthing else, if i role the car slightly and pop the clutch like barley moving the flywheel, the starter will start it, could it be somthing like a crank possition sensor problem?

so i did the 2.3 to 5.0 conversion on a 93 LX. at first this problem did'nt occur but i had the 4 cylinder starter on it that auto zone had replaced for me, surprisingly it started it thogh but wore it out pretty fast. so i went and got the correct starter, it worked great for about 5-6 weeks...

i need some help. im doing the conversion on a 93 5.0. ive got everthing hooked up and ive got fuel pump feul presure to the rail. however i have no power to my injectors. is there any way to bypass and gt a direct sorce of power to them? or any other suggestions. this makes weekend 5 on the...

ok can any one help me on this. im still having trouble with the wiring on this thing. ive got power on everything but the fuel pump. ive tested and moved the ground and i still get nothing, i used a test light on the positive wire and nothjing form the harness. the instructions dont tell me...

what is the plug in the center of the distributer cap for, it may seem like a stupid ? but i have never done distributers B4, always coil packs. can you tell me please?

i have a question that no one can answer, i have a 93 LX. i pulled the 4 cyl out and already have the 5.0 HO droped in and bolted to the T5 and everything. i am just stuck on the wiring. i got the conversion harness from ford racing and this is all i need to finish my conversion besides the...